MAX32 Просмотр технического описания (PDF) - Unspecified

Номер в каталоге

Компоненты Описание

производитель

MAX32

Max32™ Board Reference Manual

Unspecified 

Max32™ Board Reference Manual

This on-board 5V voltage regulator regulates the input voltage applied at the external power

connector to 5V. This is used to power the 3.3V regulator and to provide 5V power to expansion

shields. This regulator can provide up to 800mA of current.

7. J2: Shield Power Connector

This connector provides power to I/O expansion shields connected to the board.

8. PIC32 Microcontroller

The PIC32MX795F512L microcontroller is the main processor for the board.

9. J5, J7: Analog Signal Connectors

These connectors provides access to analog/digital I/O pins on the microcontroller.

10. User LED

LED connected to digital signal pin 13.

11. J6, J8, J9, J15: Digital Signal and Power Connectors

These are shown as four connectors in the Max32 schematic. There is a single connector loaded

across all four when the board is assembled. These provide 5V power, ground, and access to digital

I/O pins on the microcontroller to shields connected to the board.

12. JP3 & JP4: SPI Master/Slave Select Jumpers

These jumpers are used to switch the SPI signals for use of the Max32 board as an SPI master device

or as an SPI slave device. Both jumpers should be switched together. Place the shorting blocks in the

MASTER position for master operation and in the SLAVE position for slave operation. Normally, these

jumpers are in the MASTER position.

13. J13: SPI Signal Connector

This connector provides alternative access to the SPI signals. This is used by some shields for access to

the SPI bus.

14. J3, J4, J14: Digital Signal Connectors

These connectors provides access to digital I/O pins on the microcontroller.

15. J18 - I2C

Dedicated I2C signals. These signals are connected directly to I2C1 on the microcontroller and are

shared with pins 20 and 21 on connector J4.

16. Communications Status LEDs

These LEDs indicate activity on the USB serial interface.

17. Reset Button

This button can be used to reset the microcontroller, restarting operation from the boot loader.

Copyright Digilent, Inc. All rights reserved.

Other product and company names mentioned may be trademarks of their respective owners.

Page 3 of 20

Share Link: