DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

RMWD38001 Просмотр технического описания (PDF) - Fairchild Semiconductor

Номер в каталоге
Компоненты Описание
производитель
RMWD38001
Fairchild
Fairchild Semiconductor Fairchild
RMWD38001 Datasheet PDF : 8 Pages
1 2 3 4 5 6 7 8
RMWD38001
37-40 GHz Driver Amplifier MMIC
Application
Information
PRODUCT INFORMATION
CAUTION: THIS IS AN ESD SENSITIVE DEVICE.
Chip carrier material should be selected to have GaAs compatible thermal coefficient of expansion and high thermal
conductivity such as copper molybdenum or copper tungsten. The chip carrier should be machined, finished flat,
plated with gold over nickel and should be capable of withstanding 325°C for 15 minutes.
Die attachment should utilize Gold/Tin (80/20) eutectic alloy solder and should avoid hydrogen environment for
PHEMT devices. Note that the backside of the chip is gold plated and is used as RF and DC ground.
These GaAs devices should be handled with care and stored in dry nitrogen environment to prevent contamination
of bonding surfaces. These are ESD sensitive devices and should be handled with appropriate precaution including
the use of wrist grounding straps. All die attach and wire/ribbon bond equipment must be well grounded to prevent
static discharges through the device.
Recommended wire bonding uses 3 mils wide and 0.5 mil thick gold ribbon with lengths as short as practical
allowing for appropriate stress relief. The RF input and output bonds should be typically 0.012” long corresponding
to a typical 2 mil gap between the chip and the substrate material.
Figure 1
Functional Block
Diagram
Drain Supply Drain Supply Drain Supply Drain Supply
Vd1
Vd2
Vd3
Vd4
RF IN
MMIC Chip
RF OUT
Ground
(Back of Chip)
Gate Supply
Vg
Output Power
Detector Voltage Vdet
Note:
Detector delivers 0.1 V DC into 3k load resistor for >+17 dBm output power. If output power level detection is not desired, do not make
connection to detector bond pad.
Figure 2
Chip Layout and Bond
Pad Locations
Chip Size is 3.0 mm x
1.2 mm. Back of chip is
RF and DC ground
Dimensions in mm
0.0
1.2
0.8895
1.33675
2.1305
2.629
3.0
1.2
0.707
0.552
0.398
0.707
0.552
0.398
0.0
0.0
0.863
Characteristic performance data and specifications are subject to change without notice.
Revised March 14, 2001
Page 2
0.0
3.0

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]