AL8807AEV1 Просмотр технического описания (PDF) - Diodes Incorporated.

Номер в каталоге

Компоненты Описание

производитель

AL8807AEV1

AL8807AEV1 EVALUATION BOARD USER GUIDE

Diodes Incorporated. 

AL8807AEV1

AL8807AEV1 Basic operation at full voltage

1. Connect Vin and GND

Warning: The board does not feature reverse battery/supply protection.

2. Set the PSU to 36V

3. Turn on the PSU and the LED will illuminate and the current should be approximately 680mA.

Warning: Do not stare at the LED directly.

Minimising the output current

Shorting the CTRL pin to GND will cause the LED current to be reduced. On some boards, however,

the LED may not be completely turned off.

Soft start

Adding a C2 capacitor will create a soft-start power-up sequence (0.1ms/nF).

Changing the LED current

1. Remove R1.

2. Calculate and replace sense resistor, R1, the value of which is based on the required LED

current without dimming. R1 can be calculated using following equation :

R1 = 0.1V/IOUT

where IOUT = the LED current.

R1 = the sense resistor value in ohms.

0.1V is the nominal sense voltage with ‘CTRL’ open circuit or set to 2.5V.

The device calculator at the address below can be used to speed up the redesign phase:

http://www.diodes.com/destools/calculators.html

PERFORMANCE

The system efficiency depends on the sense resistor, supply voltage, switching frequency and the

number of LEDs.

With a 36V supply and one LED, the switching frequency is typically 188kHz.

The efficiency level is >85% .

For further advice, please contact your local Diodes Field Applications Engineer, or one of our

sales offices listed on the back page of this document.

Issue 1 – October 2012

© Diodes Incorporated 2012

5

www.diodes.com

Share Link: