SPX2920T-5.0 Просмотр технического описания (PDF) - Signal Processing Technologies

Номер в каталоге

Компоненты Описание

производитель

SPX2920T-5.0

400mA Low Drop Out Voltage Regulator with Shutdown

Signal Processing Technologies 

ELECTRICAL CHARACTERISTICS

Electrical characteristics at VIN = VO+1V, IO = 1mA, COUT = 2.2µF, TA = 25°C, unless otherwise specified. Boldface applies

over the full operating temperature range.

PARAMETER

CONDITIONS

(Note 2)

TYP

MIN

MAX

UNITS

Feedback Pin Bias Current

Temperature Coefficient

0.1

nA/°C

Error Comparator

Output Leakage Current

V0UT=20V

0.01

1

µA

2

Output Low Voltage

Upper Threshold Voltage

VIN=4.5V

IOUT=400µA

(Note 6)

150

250

mV

400

60

40

mV

25

Lower Threshold Voltage

(Note 6)

75

95

mV

140

Hysteresis

(Note 6)

15

mV

Shutdown Input

Input Logic Voltage

Low (Regulator ON)

High (Regulator OFF)

1.3

0.7

V

2.0

Shutdown Pin Input Current

VS=2.4V

VS=20V

30

50

µA

100

450

600

750

Regulator Output Current

in Shutdown

(Note 7)

3

10

µA

20

Note 1: Output or reference voltage temperature coefficients defined as the worst case voltage change divided by

the total temperature range.

Note 2: Additional conditions for the 8-pin versions are feedback tied to 5V/3.3V tap and output tied to output sense

(VOUT = 5V) and VSHUTDOWN ≤ 0.8V.

Note 3: Regulation is measured at constant junction temperature, using pulse testing with a low duty cycle. Changes

in output voltage due to heating effects are covered under the specification for thermal regulation.

Note 4: Line regulation for the SPX2920 is tested at 150°C for IL = 1 mA. For TJ = 125°C, line regulation is guaranteed

by design.

Note 5: Dropout voltage is defined as the input to output differential at which the output voltage drops 100 mV below

its nominal value measured at 1V differential at very low values of programmed output voltage, the minimum input

supply voltage of 2V ( 2.3V over temperature) must be taken into account.

Note 6: Comparator thresholds are expressed in terms of a voltage differential at the feedback terminal below the

nominal reference voltage measured at 6V input. To express these thresholds in terms of output voltage change,

multiply by the error amplifier gain = VOUT/VREF = (R1 + R2)/R2. For example, at a programmed output voltage of 5V,

the Error output is guaranteed to go low when the output drops by 95 mV x 5V/1.235 = 384 mV. Thresholds remain

constant as a percent of VOUT as VOUT is varied, with the dropout warning occurring at typically 5% below nominal, 7.5%

guaranteed.

Note 7: VSHUTDOWN ≥ 2V, VIN ≤ 20V, VOUT = 0, Feedback pin tied to 5V/3.3V Tap.

Rev: A Date: 03/30/04

SPX2920 400mA Low Drop Out Voltage Regulator with Shutdown

3

©Copyright 2004 Sipex Corporation

Share Link: