GA100-005WD Просмотр технического описания (PDF) - Unspecified
Номер в каталоге
Компоненты Описание
производитель
GA100-005WD Datasheet PDF : 3 Pages
| |||
Ares Series
PCB Mounted Pressure Transducers for Volume OEM Applications
The Ares Series is a small, low cost pressure transducer,
which is able to measure pressures as low as 0 to 5, 0 to
10, 0 to 15 inches of water, and 0 to 1 psig. The ranges
combined with the small physical size make the device
ideally suited for applications such as HVAC, medical
equipment and flow monitoring .
The plastic housing design for the Ares Series makes the
device very user friendly. The housing is designed to be
printed circuit board mountable, requiring no additional
hardware. Built into the housing are self locking pins
which insure a secure fit between the housing and the
PCB. The pressure ports are 3/16” barbed ports which
mate with industry standard 1/8” or 3/16” ID tubing.
These ports are mounted 90° to the printed circuit board to
allow other boards to be located above the sensor.
Providing both error correction and signal amplification,
the electronic module’s ASIC uses digital compensation
while maintaining an analog signal path, a unique design
among piezoresistive sensor products. The technique
provides the high level of error correction found in
microprocessor-based circuits but with a typical
bandwidth of >1 kHz generally found only in analog
circuits. The result is a pressure sensor that offers the
ultimate in low-cost and high accuracy, while preserving
the fast response and smooth output inherent to silicon
sensors.
The ASIC is a mixed signal CMOS sensor interface that
uses differential switched capacitor architecture, and was
specifically designed to compensate for the errors
associated with piezoresistive silicon sensors.
The heart of the Ares pressure transducer is its custom
ASIC. This ASIC, an enhanced version of the ASIC used
on the TITAN Series pressure transducer, drastically
reduces the external parts requirement for calibration. This
development allows the overall PCB size to be reduced,
while still allowing the Ares to achieve outstanding
performance characteristics. Due to its small size, barbed
pressure ports, and solder re-flow capability, the Ares
pressure transducer is ideally suited for a wide range of
applications.
Features
❏ Very Low Pressure Ranges
❏ Small Size
❏ PCB Mountable
❏ Solder Reflow Capability
❏ Barbed Pressure Ports
❏ Dry/Dry Differential Transducer
Typical Applications
❏ HVAC
❏ Medical Equipment
❏ Environmental Controls
❏ Portable Monitors
Internet: www.schaevitz.com
North America Tel: 800/745-8008
Fax Back System: 916/431-6541 Europe Tel: (01753) 537622
208
Share Link: 