HFBR-1312T Просмотр технического описания (PDF) - Avago Technologies

Номер в каталоге

Компоненты Описание

производитель

HFBR-1312T

1300 nm Fiber Optic Transmitter and Receiver

Avago Technologies 

Panel Mounting Hardware

The HFBR-4411 kit consists of 100 nuts and 100 washers

with dimensions as shown in Figure 1. These kits are

available from Avago or any authorized distributor. Any

standard size nut and washer will work, provided the total

thickness of the wall, nut, and washer does not exceed

0.2 inch (5.1 mm).

When preparing the chassis wall for panel mounting, use

the mounting template in Figure 2. When tightening the

nut, torque should not exceed 0.8 N-m (8.0 in-lb).

3/8 - 32 UNEF -

2B THREAD

Recommended Chemicals for Cleaning/Degreasing

HFBR-0300 Products

Alcohols (methyl, isopropyl, isobutyl)

Aliphatics (hexane, heptane)

Other (soap solution, naphtha)

Do not use partially halogenated hydrocarbons (such as

1.1.1 trichloroethane), ketones (such as MEK), acetone,

chloroform, ethyl acetate, methylene dichloride, phenol,

methylene chloride, or N-methylpyrolldone. Also, Avago

does not recommend the use of cleaners that use halo-

genated hydrocarbons because of their potential environ-

mental harm.

9.53 DIA.

(0.375)

(102.5.700)DIA.

HEX-NUT

1.65

(0.065)

14.27 TYP.

(0.563) DIA.

9.80

(0.386)

DIA.

10.41 MAX.

(0.410) DIA.

INTERNAL TOOTH LOCK WASHER

ALL DIMENSIONS IN MILLIMETERS AND (INCHES).

Figure 1. HFBR-4411 mechanical dimensions.

8.0

(0.315)

Figure 2. Recommended cut-out for panel mounting.

HFBR-1312T Transmitter Absolute Maximum Ratings

Parameter

Storage Temperature

Operating Temperature

Lead Soldering Cycle Temperature

Lead Soldering Cycle Time

Forward Input Current DC

Reverse Input Voltage

Symbol

Min.

Max.

Units

Reference

TS

-55

85

°C

TA

-40

85

°C

260

°C

Note 8

10

sec

IFDC

100

mA

VR

1

V

CAUTION: The small junction sizes inherent to the design of this bipolar component increase the component’s

susceptibility to damage from electrostatic discharge (ESD). It is advised that normal static precautions be taken in

handling and assembly of this component to prevent damage and/or degradation which may be induced by ESD.

4

Share Link: