EV1518DG-00A Просмотр технического описания (PDF) - Monolithic Power Systems

Номер в каталоге

Компоненты Описание

производитель

EV1518DG-00A

Fixed Frequency WLED Driver Evaluation Board

Monolithic Power Systems 

TM

EV1518DG-00A – FIXED FREQUENCY WLED DRIVER EVALUATION BOARD

PRINTED CIRCUIT BOARD LAYOUT

Figure 1—Top Silk Layer

Figure 2—Top Layer

Figure 3—Bottom Layer

QUICK START GUIDE

1. Solder LED1 – LED6 to board.

2. Connect the positive and negative terminals of the power supply (2.5V to 6V) to the VIN and

GND pins, respectively.

3. This board is set up for automatic startup. Pull EN low to shut down the MP1518.

4. To use burst mode brightness control, drive EN with a PWM signal.

NOTICE: The information in this document is subject to change without notice. Users should warrant and guarantee that third

party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not

assume any legal responsibility for any said applications.

EV1518DG-00A Rev. 1.1

www.MonolithicPower.com

3

7/25/2006

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2006 MPS. All Rights Reserved.

Share Link: