LHF16J04 Просмотр технического описания (PDF) - Sharp Electronics

Номер в каталоге

Компоненты Описание

производитель

LHF16J04

Flash Memory 16M (1M × 16/2M × 8)

Sharp Electronics 

LHFl6504

4

The access time is 90ns (tAv v) over the operating

temperature range (-40°C to +85°C) and V,- supply

voltage range of 2.7V-3.6V.

The Automatic Power Savings (APS) feature substantially

reduces active current when the device is in static mode

(addresses not switching). In APS mode, the typicaJ ICCR

current is 2pA (CMOS) at 3.OV V,,.

When CE# and RP# pins are at V,-. the I,, CMOS

standby mode is enabled. When the RP# pin is at GND,

reset mode is enabled which minimizes power

consumption and provides write protection. A reset time

(tpHQv) is required from RP# switching high until outputs

are valid. Likewise, the device has a wake time (tpHEL)

from RP#-high until writes to the CljI are recognized.

With RP# at GND, the WSM is reset and the status

register is cleared.

Please do not execute reprogramming “0” for the bit which

has already been programed “0”. Overwrite operation may

generate unerasable bit. In case of reprogramming “0” to

the data which has been programed “1”.

.Prograrn “0” for the bit in which you want to change

data from ” 1” to “0”.

.Program “1” for the bit which has already been

programmed “0”.

For example, changing data from “10111101” to

‘10111100” requires “11111110” programming.

1.3 Product Description

1.3.1 Package Pinout

LH28F160BJHE-TTL90 Boot Block Flash memory is

available in J8-lead TSOP package (see Figure 2).

1.32 Block Organization

This product features an asymmetrically-blocked

architecture providing system memory integration. Each

erase block can be erased independently of the others up to

100,000 times. For the address locations of the blocks. see

the memory map in Figure 3.

Boot Blocks: The boot block is intended to replace a

dedicated boot PROM in a microprocessor or

microcontroller-based system. This boot block 4K words

(4.096words) features hardware controllable write-

protection to protect the crucial microprocessor boot code

from accidental modification. The protection of the boot

block is controlled using a combination of the Vccw, RP#.

WP# pins and block lock-bit.

Parameter Blocks: The boot block architecture includes

parameter blocks to facilitate storage of frequently update

small parameters that would normally require an

EEPROM. By using software techniques. the word-rewrite

functionality of EEPROMs can be emulated. Each boot

block component contains six parameter blocks of 4K

words (4.096 words) each. The protection of the parameter

block is controlled using a combination of the Vccw. RP#

and block lock-bit.

Main Blocks: The reminder is divided into main blocks for

data or code storage. Each 16M-bit device contains thirty-

one 32K words (32,768 words) blocks. The protection of

the main block is controlled using a combination of the

Vccw, RP# and block lock-bit.

Rev. 1.25

Share Link: