MC1489P Просмотр технического описания (PDF) - STMicroelectronics

Номер в каталоге

Компоненты Описание

производитель

MC1489P

Quad line receivers

STMicroelectronics 

MC1489/MC1489A

8

Application information

Application information

The Electronic Industries Association (EIA) has released the RS-232C specification

detailing the requirements for the interface between data processing equipment and data

communications equipment. This standard specifies not only the number and type of

interface leads, but also the voltage levels to be used. The MC1488 quad driver and its

companion circuit, the MC1489 quad receiver, provide a complete interface system between

DTL or TTL logic levels and the RS-232C defined levels. The RS-232C requirements as

applied to receivers are discussed herein.

The required input impedance is defined as between 3000Ω and 7000Ω for input voltages

between 3.0 and 25V in magnitude; and any voltage on the receiver input in an open circuit

condition must be less than 2.0V in magnitude. The MC1489 circuits meet these

requirements with a maximum open circuit voltage of one VBE.

The receiver shall detect a voltage between - 3.0 and - 25V as a Logic "1" and inputs

between + 3.0 and + 2.5V as a Logic "0". On some interchange leads, an open circuit of

power "OFF" condition (300Ω or more to ground) shall be decoded as an "OFF" condition or

Logic "1". For the reason, the input hysteresis thresholds of the MC1489 circuits are all

above ground. Thus an open or grounded input will cause the same output as a negative or

Logic "1" input.

8.1

Device characteristics

The MC1489 interface receivers have internal feedback from the second stage to the input

stage providing input hysteresis for noise rejection. The MC1489 input has typical turn-on

voltage of 1.25V and turn-off of 1.0 V for a typical hysteresis of 250mV. The MC1489A has

typical turn-on of 1.95V and turn-off of 0.8V for typically 1.15V of hysteresis.

Each receiver section has an external response control node in addition to the input and

output pins, thereby allowing the designer to vary the input threshold voltage levels. A

resistor can be connected between this node and an external power supply. Figure 4.,

Figure 6. and Figure 7. illustrate the input threshold voltage shift possible through this

technique.

This response node can also be used for the filtering of the high-frequency, high-energy

noise pulses. Figure 11. and Figure 12. show typical noise-pulse rejection for external

capacitors of various sizes.

These two operations on the response node can be combined or used individually for may

combinations of interfacing applications. The MC1489 circuits are particularly useful for

interfacing between MOS circuits and MDTL/MTTL logic systems. In this application, the

input threshold voltages are adjusted. (with the appropriate supply and resistor values) to

fall in the center of the MOS voltage logic levels (see Figure 13.).

The response node may also be used as the receiver input as long as the designer realizes

that he may not drive this node with a low impedance source to a voltage greater than one

diode above ground or less than one diode below ground. This feature is demonstrated in

Figure 14. where two receivers are slaved to the same line that must still meet the RS-232C

impedance requirement.

11/17

Share Link: