C416 Просмотр технического описания (PDF) - Unspecified

Номер в каталоге

Компоненты Описание

производитель

C416

Platinum Resistance Temperature Detector

Unspecified 

Platinum Resistance Temperature Detector

C 416

The C series thin-film PRTDs combine the ideal curve characteristics of ceramic wire-wound RTDs with the vibration

resistance of glass wire-wound RTDs and represent an excellent alternative to wire-wound RTDs. They are characterized

by high long-term stability, excellent temperature shock resistance and a wide temperature range of -196°C to +500°C.

The deviation from the DIN EN 60751 (according to IEC 751) characteristic curve is minimal over the entire temperature

range, they show no hysteresis. These features make them best suited for applications in aerospace, chemical and power

generation plants and analytical equipment.

Nominal

Resistance R0

100 Ohm at 0°C

Tole ranc e

DIN EN 60751

1996-07

Class B

Tol era nce

DIN EN 60751

20 09 -0 5

F 0.3

Order Number

Plastic Box

32 208 519

The measuring point for the nominal resistance is defined at 8mm from the end of the sensor body.

Specification

Nominal resistance

Temperature range

Temperature coefficient

Leads

Lead lengths (L)

Long-term stability

Environmental conditions

Vibration resistance

Shock resistance

Self heating

Insulation resistance

Response time

Measuring current

Note

DIN EN 60751

100Ω at 0°C

-196°C to +500°C

Tolerance Class B: -196°C up to +500°C

TCR = 3850 ppm/K

AuPd- wire

10mm ±1mm

max. R0-drift 0.03% after 1000 h at 500 °C

unhoused for dry environments only

at least 40g acceleration at 10 to 2000 Hz,

depends on installation

at least 100g acceleration with 8ms

half sine wave, depends on installation

0.4 K/mW at 0°C

> 100 MΩ at 20°C; > 2 MΩ at 500°C

water current (v= 0.4m/s):

air stream (v= 2m/s):

t0.5 = 0.07s

t0.9 = 0.25s

t0.5 = 3.2s

t0.9 = 14.0s

100Ω: 0.3 to 1.0 mA

(self heating has to be considered)

Other tolerances, values of resistance and

wire lengths are available on request.

For brazing and soldering of the leads only brazing/solder alloys should be

used which are specified for brazing/soldering to gold alloys.

We reserve the right to make alterations and technical data printed. All technical data serves as a guideline and does not guarantee

particular properties to any products.

Heraeus Sensor Technology USA

1901 Route 130

North Brunswick, NJ 08902

Phone 732-940-4400 Fax 732-940-4445

Email info.hst-us@heraeus.com

http://heraeus-sensor-technology-us.com

Name of document: 30910002 Index B

Status: 10/2009

Share Link: