AA5001 Просмотр технического описания (PDF) - Unspecified

Номер в каталоге

Компоненты Описание

производитель

AA5001

Programmable Audio Test System

Unspecified 

TM 500 / 5000

MODULAR TEST INSTRUMENTS

Automated Audio Test System Advantages

• Fast, Accurate, Repeatable

Measurements.

• Lower Required Operator Skill.

• Automatic, Low-cost Documentation of

Test Results in Graphic or Tabular Form.

Instrument Performance Features

• Extremely low residual noise and

distortion permit measurements

on top-grade professional and

consumer audio equipment.

• Performs all standard audio tests —

THD, IMD (SMPTE, DIN, CCIF

difference tone), gain/loss, signal-

to-noise ratio.

• Analyzer input fully balanced, oscillator

output balanced or unbalanced,

floating or grounded, 50/150/600 Ω

to match all types of audio equlpment.

• Automatic swept measurements

possible without IEEE-488 controller.

• Four-or-more digit synthesized

frequency, 0.01% guaranteed accurate.

• Fully programmable filter and detector

selection to meet a wide variety of

measurement standards.

• High level oscillator output to test head

room, clipping thresholds of line level

devices.

• Ten non-volatile stored generator

setups.

• Generator includes burst, square wave,

and amplifier modes.

SG 5010 / AA 5001

Programmable AudioTest System

Automated Audio Test System Advantages

TEGAM SG 5010 and AA 5001

programmable instruments in a computer

controlled test system will make critical

audio measurements consistently,

accurately, and in two to four seconds

each. Even complex tests can be made by

non-technically-skilled operators since the

procedures are controlled by software in

the controller. And, permanent graphic or

tabular records of test results can be

produced at very low cost.

An SG 5010/AA 5001 based system

will automatically perform such industry

standard tests as harmonic distortion to

IHF A202, intermodulation distortion to

SMPTE TH 22.51, DIN 45403, IEC 268.3,

and IHF A202, frequency response to

IHF A202, and noise or signal-to-noise

ratio to IHF A202 (“A” weighting filter

complies with ANSI specification S1.4 and

IEC specification 179 for sound level

meters). With the Option 02 capability of

the AA 5001, noise measurements may be

made to CCIR 468-2 and DIN 45405

standards. The SG 5010 also generates the

burst signal necessary for dynamic

headroom tests per IHF A202.

A basic automated system consists of

the SG 5010 Programmable Oscillator, the

AA 5001 Programmable Distortion

Analyzer, and an IEEE 488 Controller.

Frequency counters, signal switchers,

interface devices, disc storage, and hard

copy units or plotters may be optionally

added to the system.

Prices and specifications subject to change without notice.

THE GLOB AL SOURCE FOR PROVEN TEST

AND MEASUREMENT TECHNOLOGY.

Share Link: