SAM7X512 Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

SAM7X512

AT91SAM ARM-based Flash MCU

Atmel Corporation 

SAM7X512/256/128 Summary

6. I/O Lines Considerations

6.1 JTAG Port Pins

TMS, TDI and TCK are schmitt trigger inputs and are not 5-V tolerant. TMS, TDI and TCK do not

integrate a pull-up resistor.

TDO is an output, driven at up to VDDIO, and has no pull-up resistor.

The JTAGSEL pin is used to select the JTAG boundary scan when asserted at a high level. The

JTAGSEL pin integrates a permanent pull-down resistor of about 15 kΩ to GND.

To eliminate any risk of spuriously entering the JTAG boundary scan mode due to noise on

JTAGSEL, it should be tied externally to GND if boundary scan is not used, or pulled down with

an external low-value resistor (such as 1 kΩ).

6.2 Test Pin

The TST pin is used for manufacturing test or fast programming mode of the

SAM7X512/256/128 when asserted high. The TST pin integrates a permanent pull-down resis-

tor of about 15 kΩ to GND.

To eliminate any risk of entering the test mode due to noise on the TST pin, it should be tied to

GND if the FFPI is not used, or pulled down with an external low-value resistor (such as 1 kΩ)

To enter fast programming mode, the TST pin and the PA0 and PA1 pins should be tied high

and PA2 tied to low.

Driving the TST pin at a high level while PA0 or PA1 is driven at 0 leads to unpredictable results.

6.3 Reset Pin

The NRST pin is bidirectional with an open drain output buffer. It is handled by the on-chip reset

controller and can be driven low to provide a reset signal to the external components or asserted

low externally to reset the microcontroller. There is no constraint on the length of the reset pulse,

and the reset controller can guarantee a minimum pulse length. This allows connection of a sim-

ple push-button on the NRST pin as system user reset, and the use of the signal NRST to reset

all the components of the system.

The NRST pin integrates a permanent pull-up resistor to VDDIO.

6.4 ERASE Pin

The ERASE pin is used to re-initialize the Flash content and some of its NVM bits. It integrates a

permanent pull-down resistor of about 15 kΩ to GND.

To eliminate any risk of erasing the Flash due to noise on the ERASE pin, it should be tied exter-

nally to GND, which prevents erasing the Flash from the application, or pulled down with an

external low-value resistor (such as 1 kΩ).

This pin is debounced by the RC oscillator to improve the glitch tolerance. When the pin is tied to

high during less than 100 ms, ERASE pin is not taken into account. The pin must be tied high

during more than 220 ms to perform the re-initialization of the Flash.

13

6120GS–ATARM–07-Apr-11

Share Link: