DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

CE-0927 Просмотр технического описания (PDF) - TDK Corporation

Номер в каталоге
Компоненты Описание
производитель
CE-0927
TDK
TDK Corporation TDK
CE-0927 Datasheet PDF : 6 Pages
1 2 3 4 5 6
CE-09xx
6
3. Notes on mounting and handling
● The connection diagrams in these handling instructions
represent the standard connection methods for this prod-
uct. Consult us for use with other connection methods.
● When a choke coil is to be connected between the input
power supply and the No.2 terminal, it should be of 4.7µH
or lower Otherwise, maximum ripple voltage may increase.
● If the ripple voltage of the input power supply is high, or
the ripple returned to input from the converter should be re-
duced, connect a capacitor with the appropriate capacity.
● For proper start-up of the converter, the start-up time of
the input voltage should be 40ms or less. The time after
the input voltage becomes 0.5V until it reaches the speci-
fied input voltage range, should be 40ms or less.
● Parallel operation of outputs for enhancing the output
current of the converter is not applicable.
● Series connection is not applicable for this product.
● Input fuse is not installed in this product.
● Do not use this product in an overload condition. Doing
so can cause failure.
● Cleaning is not applicable for this product.
● Use low-residue or non-cleaning flux.
● Notes on storage
Keep this product indoors with little temperature/humid-
ity change and away from direct sunlight. Note that if
this product is kept in a hot and humid condition or in a
condition with drastic temperature changes, it can cause
condensation, performance deterioration, or solderability
deterioration.
推奨はんだリフロー条件
Recommended reflow soldering conditions
245
225
180
150
100s max
50s max
Reflow time
・Reflow frequency: 2 times max. (mounting on rear panel not allowed)
・Using soldering copper: Within 360°C and 3s (for product terminals)
・Flow soldering not allowed
Preheating temperature: 150°C-180°C, within 100s
Soldering temperature: 245°C or lower
Solder melting temperature: 225°C or upper, within 50s
・All specifications are subject to change without notice.
web151109

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]