WM8144-10CFT/V Просмотр технического описания (PDF) - Wolfson Microelectronics plc
Номер в каталоге
Компоненты Описание
производитель
WM8144-10CFT/V
Wolfson Microelectronics plc
WM8144-10CFT/V Datasheet PDF : 27 Pages
| |||
WM8144-10
Pin Descriptions (contd.)
Pin No.
8
9
10
11
Name
CC[2]
CC[1]
CC[0]
ORNG
Type
Digital OP
Digital OP
Digital OP
Digital OP
25
OEB
Digital IP
7
DV
Digital OP
12
NRESET Digital IP
Description
Colour code outputs. These outputs indicate from which channel the
current output sample was taken (R = 00X, G = 01X, B = 10X).
Two codes are provided per channel.
Out-of-range signal, active high. This signal indicates that the current
output pixel has exceeded the maximum or minimum achievable
somewhere within the pixel processing.
Output tri-state control, all outputs (OP[9:0], DV, ORNG, CC[2:]) enabled
when OEB=0
Data valid output, active low.
Reset input, active low. This signal forces a reset of all internal registers.
24
PNS
Digital IP
Control interface parallel (high) or serial (low, default)
27
SDI/DNA Digital IP
Serial Interface: serial interface input data signal
Parallel interface: high = data, low = address
28
SCK/RNW Digital IP
Serial Interface: serial interface clock signal
Parallel interface: high = OP[9:2] is output, low = OP[9:2] is input bus
26
SEN/STB Digital IP
Serial Interface: enable, active high
Parallel interface: strobe, active low
30
DVDD1
Digital supply Positive Digital Supply (5V)
4
DVDD2
Digital supply Positive Digital Supply (5V)
41
DGND
Digital supply Digital ground (0V)
17
AVDD
Analogue supply Positive Analogue supply (5V)
18
AGND
Analogue supply Analogue Ground (0V)
5
NC
Unused
Pin must be left unconnected
6
NC
Unused
Pin must be left unconnected
Wolfson Microelectronics
7
Share Link: