ARM-JTAG-COOCOX Просмотр технического описания (PDF) - Unspecified

Номер в каталоге

Компоненты Описание

производитель

ARM-JTAG-COOCOX

STM32-P407 development board USER’S MANUAL

Unspecified 

OLIMEX© 2014

STM32-P407 user's manual

CHAPTER 2 SETTING UP THE STM32-P407 BOARD

2. Introduction to the chapter

This section helps you set up the STM32-P407 development board for the first time.

Please consider first the electrostatic warning to avoid damaging the board, then discover the

hardware and software required to operate the board.

The procedure to power up the board is given, and a description of the default board behavior is

detailed.

2.1 Electrostatic warning

STM32-P407 is shipped in a protective anti-static package. The board must not be exposed to high

electrostatic potentials. A grounding strap or similar protective device should be worn when

handling the board. Avoid touching the component pins or any other metallic element.

2.2 Requirements

In order to set up the STM32-P407, the following items are required:

- 5 Vdc power supply (or JTAG or SWD, or 5V TRACE, or 5V CAN, or 5V_USB, depending on

PWR_SEL jumper position)

- SWD interface programmer

Note 1: additionally, the board can be programmed via JTAG interface but there are signals

multiplexed with the LCD and the audio, so if using JTAG interface for programming you might

need to implement a software mechanism to stop them or you might not be able to reprogram again.

Note 2: the board can also be programmed via the USART (RS232_1) connector using the built-it

bootloader application (without the need of third-party tool). This way of programming/debugging

is slow but my provide a better/cheaper solution in certain cases. The configuration is explained in

the RS232 chapter (6.10) of the manual.

You may use a pair of the following devices for this purpose:

- ARM-JTAG-COOCOX programmer/debuuger which has both JTAG and SWD interfaces and

works natively with CooCox IDE, and Keil uVision and IAR EW via plugin

- Any of Olimex’s ARM-JTAG programmer/debugger (keeping in mind the note above)

- Any of Olimex's ARM-JTAG programmer/debugger + ARM-JTAG-SWD + Rowley CrossWorks

Also, a host-based software toolchain is required in order to program/debug the STM32-P407

board. There are also a number of ready IDEs available like CooCox IDE, IAR Embedded

Page 7 of 32

Share Link: