DFC15 Просмотр технического описания (PDF) - Power-One Inc.

Номер в каталоге

Компоненты Описание

производитель

DFC15

DFC15 SERIES DUAL OUTPUT

Power-One Inc. 

DFC15 SERIES – DUAL OUTPUT

NOTES

(1) All Parameters measured at Tc=25°C, nominal input voltage and full rated load unless otherwise noted.

Refer to the Technical Reference Section for the definition of terms, measurement circuits and other

information.

(2) Noise is measured per Technical Reference Section. Measurement bandwidth is 0-20 MHz.

(3) An input capacitor must be used for proper operation of the converter. See the DFC15 Series Application

Notes on sizing the input capacitor.

(4) Load regulation for the outputs is specified as the voltage change when both outputs are changed from

maximum to minimum at the same time.

(5) Cross regulation is defined as the change in one output when the other output is changed from full load

to 25% of full load. The converter can be run at no load on either or both outputs with no damage.

(6) Short term stability is specified after a 60 minute warmup at full load, constant line and recording the

drift over a 24 hour period.

(7) The input ripple rejection is specified for DC to 120 Hz ripple with a modulation amplitude of 1% of Vin.

DFC15 SERIES APPLICATION NOTES:

External Capacitance Requirements

An external capacitance is required for operation of the DFC15

Series. For maximum performance, it is recommended that the

DFC15 Series use a capacitor of sufficient ripple current capacity

connected across the input pins. To meet the reflected ripple

requirements of the converter, an input impedance of less than

0.05 Ohms from DC to 200KHz is required. External output

capacitance is not required for operation, however it is

recommended that 1␮F to 10␮F of tantalum and 0.001 to 0.1␮F

ceramic capacitance be selected for reduced system noise.

Additional output capacitance may be added for increased

filtering, but should not exceed 400␮F.

(continued next page)

2

Share Link: