NET1-4130 Просмотр технического описания (PDF) - Power-One Inc.

Номер в каталоге

Компоненты Описание

производитель

NET1-4130

Currents Over 100 Amps

Power-One Inc. 

NET1 SERIES

OUTPUT SPECIFICATIONS

PARAMETER

Efficiency

Ripple and Noise

Output Power

Overshoot / Undershoot

Regulation

Transient Response

Turn-on Delay

Turn-on Rise Time

CONDITIONS/DESCRIPTION

Full Rated Load, 110 VAC. Varies with distribution of loads among outputs.

Full load, 20 MHz bandwidth.

With 300 LFM forced air cooling. (Note 1)

Output voltage overshoot/undershoot at turn-on.

Varies by output. Total regulation includes: line changes over the specified.

input range, changes in load starting at 20% load and changing to 100% load.

Recovery time, to within 1% of initial set point due to a 10-100% load change,

1% max. deviation.

Time required for initial output voltage stabilization.

Time required for output voltage to rise from 10% to 90%.

AdvaRnceeledasPeroduct

MIN

TYP

MAX

80

See Model Selection Charts

240

0

See Model Selection Charts

UNITS

%

Watts

%

500

µS

2

Sec

20

mS

INTERFACE SIGNALS AND INTERNAL PROTECTION

PARAMETER

Overvoltage Protection

Overload Protection

Overtemperature Protection

Output Good

Input Power Fail Warning

Current Share

Remote Sense

CONDITIONS/DESCRIPTION

MIN

TYP

MAX

Overvoltage protection on all outputs.

Unit latches off when overvoltage is detected.

AC input must be recycled to reset.

Maximum + 0.5V

Fully protected against output overload and short circuit. Automatic recovery upon removal of overload condition.

System shutdown due to excessive internal temperature, automatic reset.

Open collector global Output Good signal. The signal activates when any of the outputs drop below 5%.

Open collector signal. Time before regulation dropout due to loss of input

5

power. May be used as independent PSOK signal in redundant applications.

Available on all outputs. Accuracy of shared current with up to 6 parallel units.

10

Single wire current share.

Available on all outputs. Total voltage compensation for cable losses with

500

respect to the main output.

UNITS

mS

%

mV

SAFETY, REGULATORY, AND EMI SPECIFICATIONS

PARAMETER

CONDITIONS/DESCRIPTION

Agency Approvals

UL1950.

CSA 22.2 NO. 234/950.

EN60950 (TÜV).

Dielectric Withstand Voltage Input to output per EN60950.

Electromagnetic Interference FCC CFR title 47 Part 15 Sub-Part B - Conducted.

EN55022 / CISPR 22 Conducted.

ESD Susceptibility

Per EN61000-4-2, level 4.

Radiated Susceptibility

Per EN61000-4-3, level 3.

EFT/Burst

Per EN61000-4-4, level 3.

Input Transient Protection

Per EN61000-4-5, class 3.

Insulation Resistance

Input to output.

MIN

Line to Line

Line to Ground

2600

B

B

8

10

±2

1

2

TYP

MAX

UNITS

Approved

VDC

Class

kV

V/M

kV

kV

10

M

NUCLEAR AND MEDICAL APPLICATIONS Power-One products are not authorized for use as critical components in life support systems,

equipment used in hazardous environments, or nuclear control systems without the express written consent of the President of Power-One, Inc.

TECHNICAL REVISIONS The appearance of products, including safety agency certifications pictured on labels, may change depending on the

date manufactured. Specifications are subject to change without notice.

2

Share Link: