OM9369SP Просмотр технического описания (PDF) - International Rectifier

Номер в каталоге

Компоненты Описание

производитель

OM9369SP

FULL-FEATURED POWER MODULE FOR HIGH VOLTAGE DIRECT DRIVE OF 3-PHASE BRUSHLESS DC MOTOR

International Rectifier 

OM9369

APPLICATIONS

Start-Up Conditions

The OM9369 3-phase brushless DC motor controller/

driver is designed to drive fractional to integral

horsepower motors. To ensure proper operation, it is

necessary to ensure that the high-side bootstrap

capcitors are charged during initial start-up. However,

the method(s) used to ensure this may be dependant

upon the application. For example, some applications

may only require that OV_COAST (pin 17) be

connected to ground, either via a hardwire connection

or via a switch (Enable/Disable), before applying Vcc.

When Vcc is applied, the controller/driver is forced

into brake mode for approximately 200µs (all high-

side drivers are disabled and all low-side drivers are

enabled).

This may not be adequate for other applications;

while maintaining a constant speed command, (above

zero), RC_BRAKE (pin 16) may have to be momentarily

connected to ground via a switch, either manually or

electronically (ref. Figure 1). Note that with the

component values shown in Figure 1, RC_BRAKE

is pulled for low for approximately 300ms after

applying Vcc at pin 1.

Fig 1: Start-Up Circuit

www.irf.com

5

Share Link: