NRVBD1035VCTLT4G(2016) Просмотр технического описания (PDF) - ON Semiconductor
Номер в каталоге
Компоненты Описание
производитель
NRVBD1035VCTLT4G Datasheet PDF : 6 Pages
| |||
MBRD1035CTL, NRVBD1035VCTL, SBRD81035CTL Series
MAXIMUM RATINGS
Rating
Symbol
Value
Unit
Peak Repetitive Reverse Voltage
Working Peak Reverse Voltage
DC Blocking Voltage
Average Rectified Forward Current
(At Rated VR, TC = 115°C)
Per Leg
Per Package
VRRM
35
V
VRWM
VR
IO
A
5.0
10
Peak Repetitive Forward Current
(At Rated VR, Square Wave, 20 kHz, TC = 115°C)
Per Leg
IFRM
A
10
Non−Repetitive Peak Surge Current
(Surge applied at rated load conditions, halfwave, single phase, 60 Hz)
Per Package
IFSM
A
50
Storage / Operating Case Temperature
Tstg, Tc
−55 to +150
°C
Operating Junction Temperature (Note 1)
TJ
−55 to +150
°C
Voltage Rate of Change (Rated VR, TJ = 25°C)
dv/dt
10,000
V/ms
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
1. The heat generated must be less than the thermal conductivity from Junction−to−Ambient: dPD/dTJ < 1/RqJA.
THERMAL CHARACTERISTICS
Rating
Thermal Resistance, Junction−to−Case
Per Leg
Thermal Resistance, Junction−to−Ambient (Note 2)
Per Leg
2. Rating applies when using minimum pad size, FR4 PC Board
Symbol
RqJC
RqJA
Value
3.0
137
Unit
°C/W
°C/W
ELECTRICAL CHARACTERISTICS
Rating
Symbol
Value
Unit
Maximum Instantaneous Forward Voltage (Note 3) (See Figure 2)
Per Leg
(IF = 5 Amps, TJ = 25°C)
(IF = 5 Amps, TJ = 100°C)
(IF = 10 Amps, TJ = 25°C)
(IF = 10 Amps, TJ = 100°C)
VF
V
0.47
0.41
0.56
0.55
Maximum Instantaneous Reverse Current (Note 3) (See Figure 4)
Per Leg
(VR = 35 V, TJ = 25°C)
(VR = 35 V, TJ = 100°C)
(VR = 17.5 V, TJ = 25°C)
(VR = 17.5 V, TJ = 100°C)
IR
mA
2.0
30
0.20
5.0
Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product
performance may not be indicated by the Electrical Characteristics if operated under different conditions.
3. Pulse Test: Pulse Width ≤ 250 ms, Duty Cycle ≤ 2.0%
www.onsemi.com
2
Share Link: 