DS28E04-100 Просмотр технического описания (PDF) - Dallas Semiconductor -> Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

DS28E04-100

4096-Bit Addressable 1-Wire EEPROM with PIO

Dallas Semiconductor -> Maxim Integrated 

DS28E04-100: 4096-Bit 1-Wire Addressable EEPROM with PIO

PIO Activity Latch State Register

ADDR b7

b6

b5

b4

b3

b2

b1

b0

0222h

0

0

0

0

0

0

AL1 AL0

The data in this register represents the current state of the PIO activity latches. This register is read using the Read

Memory command. This register is read-only. Each bit is associated with the activity latch of the respective PIO

channel. Bits 2 to 7 have no function; they always read 0. A state transition on a PIO pin, HighèLow or

LowèHigh, of a duration greater than tPWMIN causes the associated bit in the register to be set to a 1. This register

is cleared to 00h by a power-on reset, or by successful execution of the Reset Activity Latches command.

The next three registers control the device's participation a Conditional Search ROM sequence. The interaction of

the various signals that determine whether the device responds to a conditional search is illustrated in Figure 7.

There is a selection mask, SM, to select the participating PIOs, a polarity selection SP to specify for each channel

whether the channel signal needs to be 1 or 0 to qualify, and a PLS bit to select either the activity latches or PIO

pins as inputs. The signals of all channels are fed into an AND gate as well as an OR gate. The CT bit finally

selects the AND’ed or OR’ed result as the conditional search response signal CSR. If CT is 0, the channel signal of

at least one of the selected channels must match the corresponding polarity. If CT is 1, the channel signals of all

selected channels must match the corresponding polarity.

Figure 7. CONDITIONAL SEARCH LOGIC

PLS

SP0

SM0

CT

Channel 0

AL0

P0

SP1

Channel 1

AL1

P1

SM1

CSR

PORL

Conditional Search Channel Selection Mask Register

ADDR b7

b6

b5

b4

b3

b2

b1

b0

0223h

0

0

0

0

0

0

SM1 SM0

The data in this register controls whether a PIO channel qualifies for participation in the conditional search

command. To include a PIO channel, the bits in this register that correspond to those channels need to be set to 1.

This register can only be written through the Write Register command. This register is read/write. Each bit is

associated with the respective PIO channel as shown in Figure 7. Bits 2 to 7 have no function; they always read 0

and cannot be changed to 1. This register is cleared to 00h by a power-on reset.

10 of 36

Share Link: