DS2401 Просмотр технического описания (PDF) - Dallas Semiconductor -> Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

DS2401

Silicon Serial Number

Dallas Semiconductor -> Maxim Integrated 

DS2401

1-WIRE SIGNALING

The DS2401 requires a strict protocol to ensure data integrity. The protocol consists of four types of

signaling on one line: reset sequence with Reset Pulse and Presence Pulse, write 0, write 1 and read data.

All these signals except Presence Pulse are initiated by the bus master.

The initialization sequence required to begin any communication with the DS2401 is shown in Figure 5.

A reset pulse followed by a Presence Pulse indicates the DS2401 is ready to send or receive data given

the correct ROM command.

The bus master transmits (TX ) a reset pulse (tRSTL , minimum 480 µs). The bus master then releases the

line and goes into receive mode (RX ). The 1-Wire bus is pulled to a high state via the 5 kΩ pullup

resistor. After detecting the rising edge on the data pin, the DS2401 waits (tPDH, 15-60 µs) and then

transmits the Presence Pulse (tPDL , 60-240 µs).

READ/WRITE TIME SLOTS

The definitions of write and read time slots are illustrated in Figure 6. All time slots are initiated by the

master driving the data line low. The falling edge of the data line synchronizes the DS2401 to the master

by triggering a delay circuit in the DS2401. During write time slots, the delay circuit determines when the

DS2401 will sample the data line. For a read data time slot, if a “0” is to be transmitted, the delay circuit

determines how long the DS2401 will hold the data line low overriding the “1” generated by the master.

If the data bit is a 1, the DS2401 will leave the read data time slot unchanged.

5 of 10

102199

Share Link: