VS-700-LFF-HNN(2009) Просмотр технического описания (PDF) - Vectron International

Номер в каталоге

Компоненты Описание

производитель

VS-700-LFF-HNN
(Rev.:2009)

Voltage Controlled SAW Oscillator

Vectron International 

Parameter

Power Supply

Input Current

Output Current

Voltage Control Range

Storage Temperature

Soldering Temperature / Duration

Absolute Maximum Ratings

Symbol

V

CC

I

IN

I

OUT

V

C

TSTR

T /t

PEAK P

Ratings

0 to 6

100

25

0 to V

CC

-55 to 125

260 / 40

Unit

V

mA

mA

V

°C

°C / sec

Stresses in excess of the absolute maximum ratings can permanently damage the device. Also, exposure to these absolute

maximum ratings for extended periods may adversely affect device reliability. Functional operation is not implied at these or any

other conditions in excess of those represented in the operational sections of this datasheet. Permanent damage is also possible if

any device input (Vc or OD) draws >100 mA.

Suggested Output Load Configuration

LV-PECL to LV-PECL: For short transmission lengths, the power

consumption could be reduced by removing the 100Ω resistor and

doubling the value of the pull down resistors.

LV-PECL to LVDS: Restricted for short transmission lengths.

Configuration may require modification depending on LVDS receiver.

Functional Test: Allows standard power supply configuration.

Since AC coupled, the LV-PECL levels cannot be measured.

Production Test: Allows direct DC coupling into 50Ω measurement

equipment. Must bias the power supplys as shown. Similiar to figure 1.

Page3 of 7

Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com

Rev: 08Dec2009

Share Link: