AT73C500 Просмотр технического описания (PDF) - Atmel Corporation

Номер в каталоге

Компоненты Описание

производитель

AT73C500

Chip Set Solution for Watt-Hour Meters

Atmel Corporation 

Features

• Fulfills IEC 1036, Class 1 Accuracy Requirements

• Fulfills IEC 687, Class 0.5 and Class 0.2 Accuracy, with External Temperature

Compensated Voltage Reference

• Simultaneous Active, Reactive and Apparent Power and Energy Measurement

• Power Factor, Frequency, Voltage and Current Measurement

• Single and Poly Phase Operation

• Three Basic Operating Modes: Stand-Alone Mode, Microprocessor Mode and Multi-

Channel Mode

• Flexible Interfacing, 8-bit Microprocessor Interface, 8-bit Status Output and Eight

Impulse Outputs

• Calibration of Gain and Phase Error

• Compensation of the Non-Linearity of Low Power Measurement

• Adjustable Starting Current and Meter Constant

• Measurement Bandwidth of 1000 Hz

• Tamper Proof Design

• Single +5V Supply

Description

A two chip solution, consisting of AT73C500 and AT73C501 (or AT73C502), offers all

main features required for the measurement and calculation of various power and

energy quantities in static Watt-hour meters. The devices operate according to

IEC1036, class 1, specification. IEC 687, class 0.5 and 0.2 requirements are fulfilled

when used with external temperature compensated voltage reference.

The AT73C501 contains six, high-performance, Sigma-Delta analog-to-digital convert-

ers (ADC). The AT73C500 is based on an efficient digital signal processor (DSP) core

and it supports interfacing both with the AT73C501 and with an external microproces-

sor. The AT73C500 DSP can also be used with the differential input ADC, AT73C502.

With this chipset, only a minimum of discrete components is required to develop prod-

ucts ranging from simple domestic Watt-hour meters to sophisticated industrial

meters. The chipset can be used in single-phase as well as in poly-phase systems.

The DSP core of the AT73C500 is easy to configure. By changing the mode of the

AT73C500, the device can be operated in a stand-alone environment or be used with

a separate control processor. It is also possible to configure the circuit to perform the

functions of three independent single phase Wh meters.

The chips support calibration of gain and phase error. All calibrations are done in the

digital domain and no trimming components are needed. The calibration coefficients

are either stored in an EEPROM memory or supplied by an external microprocessor.

(continued)

Chip Set

Solution for

Watt-Hour

Meters

AT73C500 with

AT73C501 or

AT73C502

Rev. 1035A–08/98

1

Share Link: