SST25VF512A Просмотр технического описания (PDF) - Silicon Storage Technology
Номер в каталоге
Компоненты Описание
производитель
SST25VF512A Datasheet PDF : 25 Pages
| |||
Data Sheet
Status Register
The software status register provides status on whether the
flash memory array is available for any Read or Write oper-
ation, whether the device is Write enabled, and the state of
the memory Write protection. During an internal Erase or
512 Kbit SPI Serial Flash
SST25VF512A
Program operation, the status register may be read only to
determine the completion of an operation in progress.
Table 4 describes the function of each bit in the software
status register.
TABLE 4: SOFTWARE STATUS REGISTER
Bit Name Function
0 BUSY 1 = Internal Write operation is in progress
0 = No internal Write operation is in progress
1 WEL 1 = Device is memory Write enabled
0 = Device is not memory Write enabled
2
BP0 Indicate current level of block write protection (See Table 5)
3
BP1 Indicate current level of block write protection (See Table 5)
4:5 RES Reserved for future use
6
AAI Auto Address Increment Programming status
1 = AAI programming mode
0 = Byte-Program mode
7
BPL 1 = BP1, BP0 are read-only bits
0 = BP1, BP0 are read/writable
Busy
The Busy bit determines whether there is an internal Erase
or Program operation in progress. A “1” for the Busy bit indi-
cates the device is busy with an operation in progress. A “0”
indicates the device is ready for the next valid operation.
Write Enable Latch (WEL)
The Write-Enable-Latch bit indicates the status of the inter-
nal memory Write Enable Latch. If the Write-Enable-Latch
bit is set to “1”, it indicates the device is Write enabled. If the
bit is set to “0” (reset), it indicates the device is not Write
enabled and does not accept any memory Write (Program/
Erase) commands. The Write-Enable-Latch bit is automati-
cally reset under the following conditions:
• Power-up
• Write-Disable (WRDI) instruction completion
• Byte-Program instruction completion
• Auto Address Increment (AAI) programming
reached its highest memory address
• Sector-Erase instruction completion
• Block-Erase instruction completion
• Chip-Erase instruction completion
Default at
Power-up
0
0
1
1
0
0
Read/Write
R
R
R/W
R/W
N/A
R
0
R/W
T4.0 1264
©2006 Silicon Storage Technology, Inc.
6
S71264-02-000
1/06
Share Link: 