SPT9210SCS Просмотр технического описания (PDF) - Signal Processing Technologies
Номер в каталоге
Компоненты Описание
производитель
SPT9210SCS Datasheet PDF : 11 Pages
| |||
ABSOLUTE MAXIMUM RATINGS (Beyond which damage may occur)1
Supply Voltage
VCC ........................................................................... +6 V
Temperature
Operating Temperature ................................. 0 to +70 °C
Junction Temperature ......................................... +175 °C
Lead Temperature, (soldering 3 seconds) .......... +320 °C
Storage Temperature ................................ -55 to +150 °C
Note: 1. Operation at any Absolute Maximum Rating is not implied. See Electrical Specifications for proper nominal
applied conditions in typical applications.
ELECTRICAL SPECIFICATIONS
TA=+25 °C, VIN=1.0 VP-P, VCC=+5.0 V, unless otherwise specified.
TEST
TEST
PARAMETERS
CONDITIONS
LEVEL
MIN
Video Signal Output
Y/C Output Amplitude (pin 14)
C Output Amplitude (pin 6)
Differential Gain
Differential Phase
Automatic Gain Control
Y/C Output Amplitude (pin 14)
Y/C Output Amplitude (pin 14)
C Output Amplitude (pin 6)
C Output Amplitude (pin 6)
Composite/S-Video Mode
S-Video Mode
Composite/S-Video Mode
Composite/S-Video Mode
VIN=+3 dB
Composite/S-Video Mode
VIN=-6 dB
Composite/S-Video Mode
VIN=+3 dB
S-Video Mode
VIN=-6 dB
S-Video Mode
Clamp Circuit
Sync Tip Offset Level
C Output Bias Voltage
Composite/S-Video Mode
S-Video Mode
Anti-Alias Filter
Frequency Response
Frequency Response
Chrominance Signal Side
fIN=3 MHz, VIN=0 dB
fIN=5 MHz, VIN=0 dB
Voltage Reference
VRH (Top of Ladder)
VRL (Bottom of Ladder)
IOUT=+5 mA
IOUT=+5 mA
Digital Input (Select SW pin 1)
Logic 1 Voltage
2.0
Logic 0 Voltage
Power Supply
Supply Current ICC
No Signal
Supply Voltage VCC
4.75
TYP
2.5
0.7
0.5
0.5
2.5
2.5
0.7
0.7
1.0
2.5
7.96
4.96
3.6
1.0
70
MAX UNITS
VP-P
VP-P
%
Degrees
V
V
V
V
V
V
dB
dB
V
V
V
0.8 V
mA
5.75 V
TEST LEVEL CODES
All electrical characteristics are subject to the follow-
ing conditions: All parameters having min/max speci-
fications are guaranteed. The Test Level column
indicates the specific device testing actually per-
formed during production and Quality Assurance in-
spection. Any blank section in the data column indi-
cates that the specification is not tested at the speci-
fied condition.
TEST LEVEL
I
II
III
IV
V
VI
TEST PROCEDURE
100% production tested at the specified temperature.
100% production tested at TA = +25 °C, and sample tested
at the specified temperatures.
QA sample tested only at the specified temperatures.
Parameter is guaranteed (but not tested) by design and
characterization data.
Parameter is a typical value for information purposes only.
100% production tested at TA = +25 °C. Parameter is
guaranteed over specified temperature range.
SPT
2
SPT9210
11/7/97
Share Link: 