DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

SC16313 Просмотр технического описания (PDF) - Silan Microelectronics

Номер в каталоге
Компоненты Описание
производитель
SC16313
Silan
Silan Microelectronics Silan
SC16313 Datasheet PDF : 9 Pages
1 2 3 4 5 6 7 8 9
SC16313
data/command being transmitted is considered invalid. (However, the data/command already transmitted
remains valid)
Command 1: display mode setting command
This command initializes the SC16313 and selects the number of segments and number of grids (4 to 8
grids, 12 to 8 segments).
When this command is executed, display is forcibly turned off, and key scanning is also stopped. To resume
display, a display ON command must be executed.
SC16313 provides 4 display mode settings as shown in the diagram below. The bits 4 to 6 (b3 to b5) are
ignored, bits 7 & 8 (b6 to b7) are given a value of “0”.
On power application, the 8-digit, 8-segment mode is selected.
MSB
LSB
0 0 - - - b2 b1 b0
Don't
care
Display Mode Settings:
000: 4 digits, 12 segments
001: 5 digits, 11 segments
010: 6 digits, 10 segments
011: 7 digits, 9 segments
100: 8 digits, 8 segments
Command 2: data setting command
This command sets data write or data read modes. The data setting command, the bits 6 and 5 (b5, b4) are
ignored, bit 8 and bit 7 (b7, b6) are given the value of “01”. Please refer to the diagram below.
On power application, the normal operation mode and address increment mode are set.
MSB
LSB
0 1 - - b3 b2 b1 b0
Don't
care
Data write & read mode settings:
00: write data to display memory
10: read key data
Address increment mode settings (display
memory):
0: increment address after data has been written
1: fixes address
Test mode settings:
0: normal operation mode
1: test mode
Command 3: address setting command
This command sets an address of the display memory. The address is considered valid if it has a value of
“00H”to “0FH”. If the address is set to 10H or higher, the data is ignored until a valid address is set.
On power application, the address is set to “00H”.
Please refer to the diagram below.
MSB
LSB
1 1 0 b4 b3 b2 b1 b0
Address: 00H to 0FH
HANGZHOU MICROELECTRONICS CO.,LTD
Http: www.silan.com.cn
REV:1.2 2003.08.28
Page 5 of 10

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]