RX2 Просмотр технического описания (PDF) - Radiometrix Ltd

Номер в каталоге

Компоненты Описание

производитель

RX2

UHF FM Data Transmitter and Receiver Modules

Radiometrix Ltd 

Functional description:

The TX2 transmitter module is a two stage, SAW controlled FM transmitter operating between 2V and

6V and is available in 433.92MHz. The TX2 module is type approved to EN 300 220-3 for European use

and delivers nominally +9dBm from a 5V supply at 12mA. The module measures 32 x 12 x 3.8 mm.

The RX2 module is a double conversion FM superhet receiver capable of handling date rates of up to

160kbps. The SIL style RX2 receiver measures 48 x 17.5 x 4.5 mm. It will operate from a supply of 3-6V

and draws 14mA when receiving. A fast-acting carrier detect and a power-up enable time of less than

1ms. This allows effective duty cycle power saving and a -107 dBm sensitivity. This combined with a

SAW front-end filter results in an excellent RF performance and EMC conformance.

TX2 transmitter:

Vcc (3)

RF out (2) 433 MHz band

pass filter

+10 dBm @ 5V

433.92MHz

buffer

SAW-stabilised

oscillator

100 kHz

2nd order LPF

RF gnd (1)

Pin description:

Fig. 1: TX2 block diagram

RF GND

(pin 1)

RF ground pin, internally connected to the

module screen and pin 4 (0V). This pin should

be connected to the RF return path (e.g. coax

braid, main PCB ground plane etc.)

RF out

(pin 2)

50Ω RF output to the antenna, it is DC

isolated internally. (see antenna section for

suggested antenna/feeds).

TXD (5)

100K

0 VOLT (4)

Fig.2: physical dimensions

Vcc

(pin 3)

+ve supply pin. The module will generate RF when the Vcc supply is present. Maximum ripple content

0.1VP-P. A 100nF de-coupling ceramic capacitor is suggested.

0V

(pin 4)

Supply ground connection, connected to pin 1 and screen.

TXD

(pin 5)

This DC coupled modulation input will accept either serial digital data ( 0V to Vcc levels) or high level

linear signals. Input impedance is 100kΩ.

Radiometrix Ltd., TX2 & RX2 Data Sheet

page 2

Share Link: