PML series
Datasheet
●Derating curve
When the ambient temperature exceeds 70°C, power dissipation must be adjusted according to the derating curves below.
■P M L1 0 / 1 8 / 5 0 / 1 0 0
●Characteristics (PML10/18/50/100)
Test items
Guaranteed >
Resistor type
Resistance
See P.1
Test conditions
20℃
Measuring method : Measure Bottom termination
by4 proves.
Variation of resistance
with temperature
Overload
Solderability
Resistance to
soldering heat
Rapid change of
temperature
Damp heat, steadystate
Endurance at 70℃
Endurance
Resistance to solvent
Bend strength of
the end face plating
See P.1
Measurement:+25/-55, +25/+125℃
±(2.0%+0.0001Ω)
Rated power×2.5, 2s
Anew uniform coating of minimum
of 95% of the surface being
immersed and no soldering
damage.
Rosin-ethanol solution(25% weight)
Soldering condition:245±5℃
Duration of immersion:2.0±0.5s
±(1.0%+0.0001Ω)
Soldering condition:260±5℃
No remarkable abnormalityon the appearance. Duration of immersion:10±1s
±(1.0%+0.0001Ω)
Test temp:-55℃~+125℃ 5cycle
±(3.0%+0.0001Ω)
±(3.0%+0.0001Ω)
±(3.0%+0.0001Ω)
±(0.5%+0.0001Ω)
40℃,93%(Relative humidity)
Test time:1,000h
70℃,Rated power
1.5h:ON-0.5h:OFF
Test time:1,000h
155℃
Test time:1,000h
23±5℃ Immersion cleaning, 5±0.5min
Solvent: 2-propanol
Wihout open.
-
Compliance Standard(s) : IEC60115-8
JISC 5201-8
www.rohm.com
© 2016 ROHMCo., Ltd.All rights reserved.
3/4
2017.01 - Rev.D