DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

PCA9509 Просмотр технического описания (PDF) - Philips Electronics

Номер в каталоге
Компоненты Описание
производитель
PCA9509
Philips
Philips Electronics Philips
PCA9509 Datasheet PDF : 16 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Philips Semiconductors
PCA9509
Level translating I2C-bus/SMBus repeater
7. Application design-in information
A typical application is shown in Figure 4. In this example, the CPU is running on a 1.1 V
I2C-bus while the master is connected to a 3.3 V bus. Both buses run at 400 kHz. Master
devices can be placed on either bus.
1.1 V
3.3 V
SDA
SCL
MASTER
CPU
1.1 V
10 k
VCC(A)
10 k
VCC(B)
A1
B1
A2
B2
PCA9509
EN
10 k
SDA
SCL
SLAVE
400 kHz
bus A
bus B
002aac128
Fig 4. Typical application
When port B of the PCA9509 is pulled LOW by a driver on the I2C-bus, a CMOS
hysteresis detects the falling edge when it goes below 0.3VCC(B) and causes the internal
driver on port A to turn on, causing port A to pull down to about 0.2 V. When port A of the
PCA9509 falls, first a comparator detects the falling edge and causes the internal driver
on port B to turn on and pull the port B pin down to ground. In order to illustrate what
would be seen in a typical application, refer to Figure 5 and Figure 6. If the bus master in
Figure 4 were to write to the slave through the PCA9509, waveforms shown in Figure 5
would be observed on the B bus. This looks like a normal I2C-bus transmission.
On the A bus side of the PCA9509, the clock and data lines would have a positive offset
from ground equal to the VOL of the PCA9509. After the 8th clock pulse, the data line will
be pulled to the VOL of the master device, which is very close to ground in this example. At
the end of the acknowledge, the level rises only to the LOW level set by the driver in the
PCA9509 for a short delay while the B bus side rises above 0.5VCC(B), then it continues
HIGH. It is important to note that any arbitration or clock stretching events require that the
LOW level on the A bus side at the input of the PCA9509 (VIL) is below VILc to be
recognized by the PCA9509 and then transmitted to the B bus side.
9th clock pulse
acknowledge
SCL
SDA
PCA9509_1
Product data sheet
Fig 5. Bus B SMBus/I2C-bus waveform
Rev. 01 — 27 June 2006
002aab644
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
5 of 16

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]