PCA9506 Просмотр технического описания (PDF) - Philips Electronics
Номер в каталоге
Компоненты Описание
производитель
PCA9506 Datasheet PDF : 30 Pages
| |||
Philips Semiconductors
PCA9506
40-bit I2C-bus I/O port with RESET, OE, and INT
Table 2:
Symbol
OE
INT
RESET
Pin description …continued
Pin
TSSOP56
HVQFN56
30
23
55
48
56
49
Type Description
I
active LOW output enable input
O
active LOW interrupt output
I
active LOW reset input
[1] HVQFN package die supply ground is connected to both VSS pins and exposed center pad. VSS pins must
be connected to supply ground for proper device operation. For enhanced thermal, electrical, and board
level performance, the exposed pad needs to be soldered to the board using a corresponding thermal pad
on the board and for proper heat conduction through the board, thermal vias need to be incorporated in the
printed-circuit board in the thermal pad region.
7. Functional description
Refer to Figure 1 “Block diagram of PCA9506” and Figure 2 “Simplified schematic of
IO0_0 to IO4_7”.
7.1 Device address
Following a START condition, the bus master must send the address of the slave it is
accessing and the operation it wants to perform (read or write). The address of the
PCA9506 is shown in Figure 5. Slave address pins A2, A1, and A0 choose 1 of 8 slave
addresses and need to be connected to VDD (1) or VSS (0). To conserve power, no internal
pull-up resistors are incorporated on A2, A1, and A0.
slave address
0 1 0 0 A2 A1 A0 R/W
Fig 5. PCA9506 address
fixed
programmable
002aab494
The last bit of the first byte defines the operation to be performed. When set to logic 1 a
read is selected, while a logic 0 selects a write operation.
7.2 Command register
Following the successful acknowledgement of the slave address + R/W bit, the bus master
will send a byte to the PCA9506, which will be stored in the Command register.
AI − D5 D4 D3 D2 D1 D0
1
0
0
0
0
0
0
0
default at power-up
or after RESET
register number
Auto-Increment
002aab495
Fig 6. Command register
9397 750 14939
Product data sheet
Rev. 01 — 14 February 2006
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
7 of 30
Share Link: 