NM27C64 Просмотр технического описания (PDF) - Fairchild Semiconductor
Номер в каталоге
Компоненты Описание
производитель
NM27C64 Datasheet PDF : 10 Pages
| |||
Capacitance TA = +25˚C, f = 1 MHz (Note 2) NMC27C64Q
Symbol
CIN
COUT
Parameter
Input Capacitance
Output Capacitance
Conditions
VIN = 0V
VOUT = 0V
Typ Max Units
6
8
pF
9
12
pF
Capacitance TA = +25˚C, f = 1 MHz (Note 2) NMC27C64N
Symbol
CIN
COUT
Parameter
Input Capacitance
Output Capacitance
Conditions
VIN = 0V
VOUT = 0V
Typ Max Units
5
10
pF
8
10
pF
AC Test Conditions
Output Load
1 TTL Gate and CL = 100 pF (Note 8)
Input Rise and Fall Times
5 ns
Input Pulse Levels
0.45V to 2.4V
Timing Measurement Reference Level
Inputs
Outputs
0.8V and 2V
0.8V and 2V
AC Waveforms (Note 6) (Note 9)
ADDRESS
2V
0.8V
Address Valid
CE
2V
0.8V
2V
OE
0.8V
2V
OUTPUT
0.8V
tCE
Hi-Z
tACC
(Note 3)
tOE
(Note 3)
Valid Output
tCF
(Notes 4, 5)
tDF
(Notes 4, 5)
tOH
Hi-Z
Note 1: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of
the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
Note 2: This parameter is only sampled and is not 100% tested.
Note 3: OE may be delayed up to tACC - tOE after the falling edge of CE without impacting tACC.
Note 4: The tDF and tCF compare level is determined as follows:
High to TRI-STATE ® , the measured VOH1 (DC) ˛ 0.10V;
Low to TRI-STATE, the measured VOL1 (DC) + 0.10V.
Note 5: TRI-STATE may be attained using OE or CE .
Note 6: The power switching characteristics of EPROMs require careful device decoupling. It is recommended that at least a 0.1
between VCC and GND.
Note 7: The outputs must be restricted to VCC + 1.0V to avoid latch-up and device damage.
Note 8: 1 TTL Gate: IOL = 1.6 mA, IOH = -400 A.
CL: 100 pF includes fixture capacitance.
Note 9: VPP may be connected to VCC except during programming.
Note 10: Inputs and outputs can undershoot to -2.0V for 20 ns Max.
F ceramic capacitor be used on every device
NMC27C64 Rev. C
4
www.fairchildsemi.com
Share Link: 