AMIS−30522, NCV70522
PACKAGE THERMAL CHARACTERISTICS
The 522 is available in a NQFP32 package. For cooling
optimizations, the NQFP has an exposed thermal pad which
has to be soldered to the PCB ground plane. The ground
plane needs thermal vias to conduct the heat to the bottom
layer. Figure 3 gives an example for good power distribution
solutions.
For precise thermal cooling calculations the major
thermal resistances of the device are given. The thermal
media to which the power of the devices has to be given are:
• Static environmental air (via the case)
• PCB board copper area (via the exposed pad)
The thermal resistances are presented in Table 5: DC
Parameters.
The major thermal resistances of the device are the Rth
from the junction−to−ambient (Rthja) and the overall Rth
from the junction−to−exposed pad (Rthjp). In the table
below one can find the values for the Rthja and Rthjp,
simulated according to JESD−51:
The Rthja for 2S2P is simulated conform JEDEC JESD−51
as follows:
• A 4−layer printed circuit board with inner power planes
and outer (top and bottom) signal layers is used
• Board thickness is 1.46 mm (FR4 PCB material)
• The 2 signal layers: 70 mm thick copper with an area of
5500 mm2 copper and 20% conductivity
• The 2 power internal planes: 36 mm thick copper with
an area of 5500 mm2 copper and 90% conductivity
The Rthja for 1S0P is simulated conform JEDEC JESD−51
as follows:
• A 1−layer printed circuit board with only 1 layer
• Board thickness is 1.46 mm (FR4 PCB material)
• The layer has a thickness of 70 mm copper with an area
of 5500 mm2 copper and 20% conductivity
ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎNÎÎÎÎQFPÎÎÎÎ−32ÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎ
Figure 3. Example of NQFP−32 PCB Ground Plane Layout in Top View (Preferred Layout at Top and Bottom)
ELECTRICAL SPECIFICATION
Recommended Operation Conditions
Operating ranges define the limits for functional
operation and parametric characteristics of the device. Note
that the functionality of the chip outside these operating
Table 4. OPERATING RANGES
Symbol
Parameter
VBB
Analog DC supply
VDD
Logic supply output voltage
TJ
Junction temperature
5. No more than 100 cumulative hours in life time above Ttw
ranges is not guaranteed. Operating outside the
recommended operating ranges for extended periods of time
may affect device reliability.
Min
Max
Unit
+6
+30
V
4.75
5.25
V
−40
+172 (Note 5)
°C
http://onsemi.com
5