NCP5010 Просмотр технического описания (PDF) - ON Semiconductor
Номер в каталоге
Компоненты Описание
производитель
NCP5010 Datasheet PDF : 18 Pages
| |||
NCP5010
Vbat
2.7 to 5.5 V
Cin
4.7 mF 0603
L1
22 mH
LED
X5R 6.3V
ENABLE
A2
CTRL
A3
NC
NCP5010
VOUT C1
Cout
1 mF 0805
X5R 25V
LED
Rfb
24
Figure 2. Typical Application Circuit
PIN FUNCTION DESCRIPTION
PIN PIN NAME TYPE
A1
AGND POWER
B1
VIN
POWER
C1
VOUT
POWER
A2
CTRL
INPUT
C2
SW
POWER
A3
NC
N/A
B3
FB
INPUT
C3
PGND POWER
DESCRIPTION
System ground for the analog circuitry. A high quality ground must be provided to avoid spikes and/
or uncontrolled operations. This pin is to be connected to the PGND pin.
Power Supply Input. A ceramic capacitor with a minimum value of 1 mF/6.3 V (X5R or X7R) must be
connected to this pin. This capacitor should be placed as close as possible to this pin. In addition,
one end of the external inductor is to be connected at this point.
DC−DC converter output. This pin should be directly connected to the load and a low ESR
(<30 mW) 1 mF (min) 25 V bypass capacitor. This capacitor is required to smooth the current flowing
into the load, thus limiting the noise created by the fast transients present in this circuit. Since this is
a current regulated output, this pin has over voltage protection to protect from open load conditions.
Care must be taken to avoid EMI through the PCB copper tracks connected to this pin.
An Active High logic level on this pin enables the device. A built−in pulldown resistor disables the
device if the pin is left open. This pin can also be used to control the average current into the load
by applying a low frequency PWM signal. If a PWM signal is applied, the frequency should be high
enough to avoid optical flicker but be no greater than 1 kHz.
Power switch connection for inductor. Typical application will use a coil from 10 mH to 22 mH and
must be able to handle at least 350 mA. If the desired output power is above 300 mW, the inductor
should have a DCR < 1.4 W.
Not Connected
Feedback voltage input used to close the loop by means of a sense resistor connected between the
primary LED branch and the ground. The output current tolerance is depends upon the accuracy of
this resistor and a ±5% or better accuracy metal film resistor is recommended. An analog dimming
signal can be applied to this point to reduce the output current. Please refer to the application
section for additional details.
Power ground. A high quality ground must be used to avoid spikes and/or uncontrolled operation.
Care must be taken to avoid high−density current flow in a limited PCB copper track. This pin is to
be connected to the AGND pin.
http://onsemi.com
2
Share Link: 