NCP102
EN
SOFT-S
VCC
IEN
9.75 V
VCC
ISOFT-S
UVLO
+
-
0.8 V
VCC
15 V
GND
0.8 V
+
FB
9.75 V
-
9.75 V
DRV
Figure 2. Representative Block Diagram
PIN FUNCTION DESCRIPTION
Pin Symbol Name
Description
1
EN
Enable Input (Active High). Pull the EN pin below 0.8 V to disable the regulator and enter the standby
mode operation.
2
GND
Ground
3
FB
Inverting input of the error amplifier. The output voltage is sampled by means of a resistor divider and ap‐
plied to this pin for regulation.
4
SOFT-S
Programmable soft-start. An internal current source charges the capacitor connected to this pin. The soft-
start period ends once the voltage of the soft-start capacitor reaches 0.8 V.
5
DRV
Gate drive for external N-Channel MOSFET. It is also the buffered output of the error amplifier.
6
VCC
Power supply voltage input. Operating voltage range is from 4.5 to 13.5 V. A decoupling capacitor to GND
should be used. A minimum of 0.1 mF is recommended.
http://onsemi.com
2