NCP1015 Просмотр технического описания (PDF) - ON Semiconductor
Номер в каталоге
Компоненты Описание
производитель
NCP1015 Datasheet PDF : 22 Pages
| |||
NCP1015
Self-Supplied Monolithic
Switcher for Low Standby-
Power Offline SMPS
The NCP1015 integrates a fixed−frequency current−mode
controller and a 700 V voltage MOSFET. Housed in a PDIP−7 or
SOT−223 package, the NCP1015 offers everything needed to build a
rugged and low−cost power supply, including soft−start, frequency
jittering, short−circuit protection, skip−cycle, a maximum peak
current set−point and a Dynamic Self−Supply (no need for an auxiliary
winding).
Unlike other monolithic solutions, the NCP1015 is quiet by nature:
during nominal load operation, the part switches at one of the available
frequencies (65−100 kHz). When the current set−point falls below a
given value, e.g. the output power demand diminishes, the IC
automatically enters the so−called skip cycle mode and provides
excellent efficiency at light loads. Because this occurs at typically 0.25
of the maximum peak value, no acoustic noise takes place. As a result,
standby power is reduced to the minimum without acoustic noise
generation.
Short−circuit detection takes place when the feedback signal fades
away e.g. un−true short−circuit or is broken optocoupler cases. Finally
soft−start and frequency jittering further ease the designer task to
quickly develop low−cost and robust offline power supplies.
For improved standby performance, the connection of an auxiliary
winding stops the DSS operation and helps to consume less than
100 mW at high line.
Features
• Built−in 700 V MOSFET with typical RDS(on) of 11 W
• Large Creepage Distance between High−voltage Pins
• Current−mode Fixed Frequency Operation: 65 kHz − 100 kHz
• Skip−cycle Operation at Low Peak Currents Only: No Acoustic Noise!
• Dynamic Self−Supply, No Need for an Auxiliary Winding
• Internal 1 ms Soft−start
• Auto−recovery Internal Output Short−circuit Protection
• Frequency Jittering for Better EMI Signature
• Below 100 mW Standby Power if Auxiliary Winding is Used
• Internal Temperature Shutdown
• Direct Optocoupler Connection
• SPICE Models Available for TRANsient and AC Analysis
• This is a Pb−Free Device
http://onsemi.com
MARKING
DIAGRAMS
8
1
PDIP−7
CASE 626A
AP SUFFIX
P1015APyy
AWL
YYWWG
1
4
4
SOT−223
CASE 318E
1
ST SUFFIX
AYW
1015y G
G
1
yy
y
A
WL
YY
WW
G or G
= 06 (65 kHz), 10 (100 kHz)
= A (65 kHz), B (100 kHz)
= Assembly Location
= Wafer Lot
= Year
= Work Week
= Pb−Free Package
(*Note: Microdot may be in either location)
PIN CONNECTIONS
PDIP−7
VCC 1
NC 2
8 GND
7 GND
GND 3
FB 4
5 DRAIN
(Top View)
SOT−223
VCC 1
FB 2
4 GND
Typical Applications
• Low Power ac−dc Adapters for Chargers
• Auxiliary Power Supplies (USB, Appliances, TVs, etc.)
DRAIN 3
(Top View)
© Semiconductor Components Industries, LLC, 2011
March, 2011 − Rev. 3
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 20 of this data sheet.
1
Publication Order Number:
NCP1015/D
Share Link: 