NM25C640 Просмотр технического описания (PDF) - Fairchild Semiconductor

Номер в каталоге

Компоненты Описание

производитель

NM25C640

64K-Bit Serial CMOS EEPROM (Serial Peripheral Interface (SPI) Synchronous Bus)

Fairchild Semiconductor 

Functional Description

TABLE 1. Instruction Set

Instruction Instruction

Name Opcode

Operation

WREN

00000110 Set Write Enable Latch

WRDI

00000100 Reset Write Enable Latch

RDSR

00000101 Read Status Register

HOLD: The HOLD pin is used in conjunction with the CS to select

the device. Once the device is selected and a serial sequence is

underway, HOLD may be forced low to suspend further serial

communication with the device without resetting the serial se-

quence. Note that HOLD must be brought low while the SCK pin

is low. The device must remain selected during this sequence. To

resume serial communication HOLD is brought high while the

SCK pin is low. The SO pin is at a high impedance state during

HOLD.

WRSR

00000001 Write Status Register

INVALID OP-CODE: After an invalid code is received, no data is

READ

00000011 Read Data from Memory

shifted into the NM25C640, and the SO data output pin remains

Array

high impedance until a new CS falling edge reinitializes the serial

communication. See Figure 5 .

WRITE

00000010 Write Data to Memory Array

 MASTER: The device that generates the serial clock is desig-

nated as the master. The NM25C640 can never function as a

master.

SLAVE: The NM25C640 always operates as a slave as the serial

clock pin is always an input.

TRANSMITTER/RECEIVER: The NM25C640 has separate pins

for data transmission (SO) and reception (SI).

FIGURE 5. Invalid Op-Code

CS

SI

INVALID CODE

SO

MSB: The Most Significant Bit is the first bit transmitted and

received.

DS500041-7

CHIP SELECT: The chip is selected when pin CS is low. When the

chip is not selected, data will not be accepted from pin SI, and the

output pin SO is in high impedance.

SERIAL OP-CODE: The first byte transmitted after the chip is

selected with CS going low contains the op-code that defines the

operation to be performed.

PROTOCOL: When connected to the SPI port of a 68HC11

microcontroller, the NM25C640 accepts a clock phase of 0 and a

clock polarity of 0. The SPI protocol for this device defines the byte

transmitted on the SI and SO data lines for proper chip operation.

See Figure 4.

FIGURE 4. SPI Protocol

CS

  SCK

…

SI

Bit 7 Bit 6 … Bit 0

SO

Bit 7 … Bit 1 Bit 0

DS500041-5

Data is clocked in on the positive SCK edge and out on the

negative SCK edge.

NM25C640 Rev. D.2

6

www.fairchildsemi.com

Share Link: