MT9076AB Просмотр технического описания (PDF) - Mitel Networks

Номер в каталоге

Компоненты Описание

производитель

MT9076AB

T1/E1/J1 3.3V Single Chip Transceiver

Mitel Networks 

Preliminary Information

MT9076

LIU

The MT9076 LIU interfaces the digital framer functions to either the DS1 (T1 mode) or PCM 30 (E1 mode)

transformer-isolated four wire line.

In T1 mode, the LIU can pre-equalize the transmit signal to meet the T1.403 and T1.102 pulse templates after

attenuation by 0 - 655 feet of 22 AWG PIC cable, alternatively it can provide line build outs of 7.5dB, 15dB and

22.5dB. In T1 mode the receiver can recover signals attenuated by up to 43dB at 772kHz.

In E1 mode, the LIU transmits signals that meet the G.703 2.048 Mbit/s pulse template and the receiver can

recover signals attenuated by up to 43dB at 1024kHz.

Digitial Framer Only Mode

To accommodate some special applications, the MT9076 supports a digital framer only mode that provides

direct access to the transmit and receive data in digital format, i.e. by-passing the analog LIU front-end. In

digital framer only mode, the MT9076 supports unipolar non-return to zero or bipolar return to zero data.

PLL and Slip Buffers

The MT9076 PLL attenuates jitter from 2.5 Hz with a roll-off of 20 dB/decade. The intrinsic jitter is less than

0.02 UI. The device can operate in one of three timing modes: System Bus Synchronous Mode, Line

Synchronous Mode, or Free-run Mode. In all three timing modes the low jitter output of the PLL provides timing

to the transmit side of the LIU.

In T1 mode, the receive and transmit paths both include two-frame slip buffers. The transmit slip buffer features

programmable delay and serves as a Jitter Attenuator (JA) FIFO and a rate converter between the ST-BUS and

the 1.544 Mbit/s T1 line rate.

In E1 mode, the receive path includes a two-frame slip buffer and the transmit path contains a 128 bit Jitter

Attenuator (JA) FIFO with programmable depth.

Interface to the System Backplane

On the system side the MT9076 framers can interface to a 2.048Mbit/s or 8.192Mbit/s ST-BUS backplane.

There is an asynchronous mode for Inverse MUX for ATM (IMA) applications, this enables the framer to

interface to a 1.544Mbit/s (T1) or 2.048Mbit/s (E1) serial bus with asynchronous transmit and receive timing.

Framing Modes

The MT9076 framers operate in termination mode or transparent mode. In the receive transparent mode, the

received line data is channelled to the DSTo pin with arbitrary frame alignment. In the transmit transparent

mode, no framing or signaling is imposed on the data transmitted from the DSTi pin onto the line.

In T1 mode, the framers operate in any of the following framing modes: D4, Extended Superframe (ESF) or

SLC-96.

In E1 mode, the framers run three framing algorithms: basic frame alignment, signaling multiframe alignment

and CRC-4 multiframe alignment. The Remote Alarm Indication (RAI) bit is automatically controlled by an

internal state machine.

7

Share Link: