M27C64A-10K1 Просмотр технического описания (PDF) - STMicroelectronics

Номер в каталоге

Компоненты Описание

производитель

M27C64A-10K1

64 Kbit (8Kb x8) UV EPROM and OTP EPROM

STMicroelectronics 

M27C64A

Device operation

be a high frequency capacitor of low inherent inductance and should be placed as close to

the device as possible. In addition, a 4.7µF bulk electrolytic capacitor should be used

between VCC and VSS for every eight devices. The bulk capacitor should be located near the

power supply connection point. The purpose of the bulk capacitor is to overcome the voltage

drop caused by the inductive effects of PCB traces.

2.5

Programming

When delivered (and after each erasure for UV EPROM), all bits of the M27C64A are in the

"1" state. Data is introduced by selectively programming "0"s into the desired bit locations.

Although only "0"s will be programmed, both "1"s and "0"s can be present in the data word.

The only way to change a "0" to a "1" is by die exposition to ultraviolet light (UV EPROM).

The M27C64A is in the programming mode when VPP input is at 12.5V, E is at VIL and P is

pulsed to VIL. The data to be programmed is applied to 8 bits in parallel to the data output

pins. The levels required for the address and data inputs are TTL. VCC is specified to be 6V

± 0.25V.

2.6

High-speed programming

The high speed programming algorithm, described in Figure 4, rapidly programs the

M27C64A using an efficient and reliable method, particularly suited to the production

programming environment. An individual device will take around 1 minute to program.

Figure 4.

Programming Flowchart

VCC = 6V, VPP = 12.5V

n=1

NO

++n

> 25

YES

FAIL

P = 1ms Pulse

NO

VERIFY

++ Addr

YES

P = 3ms Pulse by n

Last NO

Addr

YES

CHECK ALL BYTES

1st: VCC = 6V

2nd: VCC = 4.2V

AI01167

9/22

Share Link: