MC33690 Просмотр технического описания (PDF) - Freescale Semiconductor

Номер в каталоге

Компоненты Описание

производитель

MC33690

Standalone Tag Reader Circuit

Freescale Semiconductor 

ISO 9141 Physical Interface

also the input generating the internal reset signal. Applying a logic low level on this pin resets the circuit, all the internal flip

flops are reset, and drivers TD1/2 are switched on.

VBAT

C1

VSUP

1 MHz oscillator

Charge pump

Voltage reference

-

and biasing

VDD

generator

+

CReset

10mA VDD

LVR

reset

Comparator -

+

GATE

N channel

LDMOS

SOURCE

P channel

MOS

VDD

VDD C2

C3

10mF 100nF

Figure 4. Voltage Regulator Block Diagram

5 ISO 9141 Physical Interface

This interface module is fully compatible with the ISO 9141 norm describing the diagnosis line. It includes one transmitter

(pin K) and two receivers (pins K and AM).

The input stages consist of high-voltage CMOS triggers. The thresholds are ratiometric to VSUP. A ground referenced current

source (2.5µA typ.) pulls down the input when unconnected.

When a negative voltage is applied on the K or AM lines, the input current is internally limited by a 2kΩ resistor (typ.) in series

with a diode.

A current limitation allows the transmitter to drive any capacitive load and protects against short circuit to the battery voltage.

An overtemperature protection shuts the driver down when the junction temperature exceeds 150°C (typ). After shutdown by

the overtemperature protection, the driver can be switched on again if the junction temperature has decreased below the

threshold and by applying an off/on command, coming from the demodulator in configurations A and B, or directly applied on

the input Tx in configuration C (see Table 4).

The electromagnetic emission is reduced because of the voltage slew rate control (5V/µs typ.).

MC33690 Standalone Tag Reader Circuit, Rev. 5

8

Freescale Semiconductor

Share Link: