MC10SX1190 Просмотр технического описания (PDF) - ON Semiconductor
Номер в каталоге
Компоненты Описание
производитель
MC10SX1190 Datasheet PDF : 6 Pages
| |||
MC10SX1190
Table 4. AC CHARACTERISTICS (VCC = 3.0 V to 5.5 V, VEE = 0 V) (Note 11)
−40°C
25°C to 85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Unit
tpd
Propagation Delay−to−Output DR → QR (Diff) (Notes 12 and 13) 140 240 340 180 280 380 ps
DR → QT (Diff) 300 400 500 350 470 650
DT → QT (Diff) 280 380 480 350 440 650
tPLH,
tPHL
Propagation Delay
(1.5 V to 50% Pt)
SEL → QT,QT 400 700 1000 400 700 1000 ps
tr,
Rise Time (20% to 80%)
tf
Fall Time (80% to 20%)
QR,QR 70 140 200 90 155 250 ps
tr,
Rise Time (20% to 80%)
tf
Fall Time 80% to 20%
QT,QT 150 200 280 150 230 500 ps
230
tskew
VPP
VCMR
fmax
Within Device Skew (Note 14)
Input Swing (Differential Configuration)
Common Mode Range (Note 15)
Maximum Operation Frequency
15
15
ps
200
1000 200
1000 mV
3.0
4.35 3.0
4.35 V
2.5
2.5
Gb/s
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit
values are applied individually under normal operating conditions and not valid simultaneously.
11. VEE can vary +0.3 V to −0.3 V
12. The differential propagation delay is defined as the delay from the crossing points of the differential input signals to the crossing point of the
differential output signals.
13. The single-ended propagation delay is defined as the delay from the 50% point of the input signal to the 50% point of the output signal.
14. Duty cycle skew is the difference between tPLH and tPHL propagation delay through a device.
15. The CMR range is referenced to the most positive side of the differential input signal. Normal operation is obtained if the HIGH level falls
within the specified range and the peak-to-peak voltage lies between VPP Min and 1.0 V.
http://onsemi.com
4
Share Link: 