MBM29F080A Просмотр технического описания (PDF) - Spansion Inc.

Номер в каталоге

Компоненты Описание

производитель

MBM29F080A

FLASH MEMORY CMOS 8M (1M ×8) BIT

Spansion Inc. 

FUJITSU SEMICONDUCTOR

DATA SHEET

FLASH MEMORY

CMOS

8M (1M × 8) BIT

DS05-20850-4E

MBM29F080A-55/-70/-90

s GENERAL DESCRIPTION

The MBM29F080A is a 8 M-bit, 5.0 V-Only Flash memory organized as 1 M bytes of 8 bits each. The 1 M bytes

of data is divided into 16 sectors of 64 K bytes for flexible erase capability. The 8 bit of data will appear on DQ0

to DQ7. The MBM29F080A is offered in a 48-pin TSOP(I), 40-pin TSOP, and 44-pin SOP packages. This device

is designed to be programmed in-system with the standard system 5.0 V VCC supply. A 12.0 V VPP is not required

for program or erase operations. The device can also be reprogrammed in standard EPROM programmers.

The standard MBM29F080A offers access times between 55 ns and 90 ns allowing operation of high-speed

microprocessors without wait states. To eliminate bus contention the device has separate chip enable (CE), write

enable (WE), and output enable (OE) controls.

The MBM29F080A is command set compatible with JEDEC standard E2PROMs. Commands are written to the

command register using standard microprocessor write timings. Register contents serve as input to an internal

state-machine which controls the erase and programming circuitry. Write cycles also internally latch addresses

and data needed for the programming and erase operations. Reading data out of the device is similar to reading

from 12.0 V Flash or EPROM devices.

The MBM29F080A is programmed by executing the program command sequence. This will invoke the Embedded

Program Algorithm which is an internal algorithm that automatically times the program pulse widths and verifies

proper cell margin. Each sector can be programmed and verified in less than 0.5 seconds. Erase is accomplished

by executing the erase command sequence. This will invoke the Embedded Erase Algorithm which is an internal

algorithm that automatically preprograms the array if it is not already programmed before executing the erase

operation. During erase, the device automatically times the erase pulse widths and verifies proper cell margin.

s PRODUCT LINE UP

(Continued)

Part No.

MBM29F080A

VCC = 5.0 V ±5%

-55

—

—

Ordering Part No.

VCC = 5.0 V ±10%

—

-70

-90

Max Address Access Time (ns)

55

70

90

Max CE Access Time (ns)

55

70

90

Max OE Access Time (ns)

30

30

40

Share Link: