MAX8863 Просмотр технического описания (PDF) - Maxim Integrated
Номер в каталоге
Компоненты Описание
производитель
MAX8863 Datasheet PDF : 10 Pages
| |||
MAX8863T/S/R,
MAX8864T/S/R
Low-Dropout, 120mA Linear Regulators
Pin Description
PIN NAME
FUNCTION
1
SHDN
Active-Low Shutdown Input. A logic low reduces the supply current to 0.1nA. On the MAX8864, a logic low also
causes the output voltage to discharge to GND. Connect to IN for normal operation.
2
GND
Ground. This pin also functions as a heatsink. Solder to large pads or the circuit board ground plane to
maximize thermal dissipation.
3
IN
Regulator Input. Supply voltage can range from +2.5V to +6.5V. Bypass with 1µF to GND (see Capacitor
Selection and Regulator Stability).
4
OUT
Regulator Output. Fixed or adjustable from +1.25V to +6.5V. Sources up to 120mA. Bypass with a 1µF,
< 0.2Ω typical ESR capacitor to GND.
Feedback Input for Setting the Output Voltage. Connect to GND to set the output voltage to the preset
5
SET 2.80V (MAX886_R), 2.84V (MAX886_S), or 3.15V (MAX886_T). Connect to an external resistor- divider for
adjustable-output operation.
Detailed Description
The MAX8863/MAX8864 are low-dropout, low-quiescent-
current linear regulators designed primarily for battery-
powered applications. They supply an adjustable 1.25V
to 6.5V output or a preselected 2.80V (MAX886_R),
2.84V (MAX886_S), or 3.15V (MAX886_T) output for load
currents up to 120mA. As illustrated in Figure 1, these
devices consist of a 1.25V reference, error amplifier,
MOSFET driver, P-channel pass transistor, Dual Mode™
comparator, and internal feedback voltage divider.
The 1.25V bandgap reference is connected to the error
amplifier’s inverting input. The error amplifier compares
this reference with the selected feedback voltage and
amplifies the difference. The MOSFET driver reads the
error signal and applies the appropriate drive to the
P-channel pass transistor. If the feedback voltage is lower
than the reference, the pass-transistor gate is pulled
lower, allowing more current to pass and increasing the
output voltage. If the feedback voltage is too high, the
pass-transistor gate is pulled up, allowing less current to
pass to the output.
The output voltage is fed back through either an internal
resistor voltage divider connected to the OUT pin, or an
external resistor network connected to the SET pin. The
Dual Mode comparator examines the SET voltage and
selects the feedback path. If SET is below 60mV, internal
feedback is used and the output voltage is regulated to
the preset output voltage. Additional blocks include a
current limiter, reverse battery protection, thermal sensor,
and shutdown logic.
IN
SHDN
REVERSE
BATTERY
PROTECTION
MAX8863
MAX8864
SHUTDOWN
LOGIC
GND
* AUTO-DISCHARGE, MAX8864 ONLY
Figure 1. Functional Diagram
THERMAL
SENSOR
www.maximintegrated.com
ERROR
AMP
MOS DRIVER
WITH ILIMIT
P
N
OUT
*
SET
1.25V
REF
DUAL-MODE
COMPARATOR
60mV
Maxim Integrated │ 6
Share Link: 