MAX3264 Просмотр технического описания (PDF) - Maxim Integrated

Номер в каталоге

Компоненты Описание

производитель

MAX3264

+3.0V to +5.5V, 1.25Gbps/2.5Gbps Limiting Amplifiers

Maxim Integrated 

+3.0V to +5.5V, 1.25Gbps/2.5Gbps

Limiting Amplifiers

Input Buffer

The input buffer is designed to accept input signals

from the MAX3266/MAX3267 transimpedance ampli-

fiers. The input buffer provides a 100Ω input imped-

ance between IN+ and IN-. Input VSWR is typically less

than 2.0 for frequencies less than 2GHz. DC-coupling

the inputs is not recommended; this prevents the DC

offset-correction circuitry from functioning properly.

Gain Stage and Offset Correction

The limiting amplifier provides approximately 55dB

(MAX3264/MAX3268/MAX3768) or 49dB (MAX3265/

MAX3269/MAX3765) of gain. This large gain makes the

amplifier susceptible to small DC offsets in the input sig-

nal. DC offsets as low as 1mV reduce the accuracy of

the power-detection circuit and may cause deterministic

jitter. A low-frequency feedback loop is integrated into

the limiting amplifier to reduce input offset, typically to

less than 100µV.

An external capacitor connected between CAZ1 and

CAZ2, in parallel with internal capacitance, determines

the time constant of the offset-correction circuit. The off-

set-correction circuit requires an average data-input

mark density of 50% to prevent an increase in duty-

cycle distortion and to ensure low deterministic jitter.

VCC

CML Output Buffer

The MAX3264/MAX3265/MAX3765 CML output circuits

(Figure 7) provide high tolerance to impedance mis-

matches and inductive connectors. The output current

can be set to two levels. When the LEVEL pin is left

unconnected, output current is approximately 16mA.

Connecting LEVEL to ground sets the output current to

approximately 20mA.

The squelch function is enabled when the SQUELCH pin

is set to a TTL-high level or connected to VCC. The

squelch function holds OUT+ and OUT- at a static volt-

age whenever the input signal power drops below the

loss-of-signal threshold. In the 10-pin µMAX package of

the MAX3265/MAX3268/MAX3269, the SQUELCH func-

tion is left internally unconnected. In the MAX3765/

MAX3768, the SQUELCH function is always enabled by

internally connecting it to VCC. SQUELCH operation for

the MAX3264/MAX3265 is described in Table 1.

Table 1.

LEVEL PIN

Open

GND

VOLTAGE WHEN SQUELCHED

OUT-

OUT+

VCC - 100mV

VCC

VCC - 100mV

VCC - 100mV

Internal Input/Output Schematics

0.25pF

IN+

IN-

0.25pF

500Ω

500Ω

110Ω

VCC

RT

LOS

ESD

STRUCTURES

ESD

STRUCTURE

GND

RT = 8kΩ (MAX3265/MAX3269/MAX3765)

RT = 16kΩ (MAX3264/MAX3268/MAX3768)

GND

Figure 4. Input Circuit

Figure 5. LOS Output Circuit

______________________________________________________________________________________ 11

Share Link: