LTC1415 Просмотр технического описания (PDF) - Linear Technology
Номер в каталоге
Компоненты Описание
производитель
LTC1415 Datasheet PDF : 24 Pages
| |||
LTC1415
TYPICAL PERFORMANCE CHARACTERISTICS
Power Supply Feedthrough vs
Ripple Frequency
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
– 100
1k
VDD
DGND
OVDD
10k
100k
1M 2M
RIPPLE FREQUENCY (Hz)
LTC1415 • TPC08
Input Common Mode Rejection
vs Input Frequency
80
70
60
50
40
30
20
10
0
1k
10k
100k
1M 2M
INPUT FREQUENCY (Hz)
LTC1415 • TPC09
UU U
PI FU CTIO S
+ AIN (Pin 1): Positive Analog Input, 0V to 4.096V.
– AIN (Pin 2): Negative Analog Input, 0V to 4.096V.
VREF (Pin 3): 2.50V Reference Output.
REFCOMP (Pin 4): Bypass to AGND with 10µF tantalum
in parallel with 0.1µF or 10µF ceramic.
AGND (Pin 5): Analog Ground.
D11 to D4 (Pins 6 to 13): Three-State Data Outputs.
DGND (Pin 14): Digital Ground.
D3 to D0 (Pins 15 to 18): Three-State Data Outputs.
OGND (Pin 19): Digital Output Buffer Ground.
NAP/SLP (Pin 20): Power Shutdown Mode. High for
quick wake-up Nap mode.
SHDN (Pin 21): Power Shutdown Input. A low logic
level will invoke the Shutdown mode selected by the
NAP/SLP pin. Tie high if unused.
RD (Pin 22): Read Input. This enables the output
drivers when CS is low.
CONVST (Pin 23): Conversion Start Signal. This active
low signal starts a conversion on its falling edge.
CS (Pin 24): The Chip Select input must be low for the
ADC to recognize CONVST and RD inputs.
BUSY (Pin 25): The BUSY output shows the converter
status. It is low when a conversion is in progress. Its
rising edge may be used to latch the output data.
0VDD (Pin 26): Digital output buffer supply. Short to Pin
28 for 5V output. Tie to 3V for driving 3V logic.
DVDD (Pin 27): 5V Positive Supply. Short to Pin 28.
AVDD (Pin 28): 5V Positive Supply. Bypass to AGND
with 10µF tantalum in parallel with 0.1µF or 10µF
ceramic.
6
Share Link: 