LT3470H Просмотр технического описания (PDF) - Linear Technology
Номер в каталоге
Компоненты Описание
производитель
LT3470H Datasheet PDF : 20 Pages
| |||
LT3470
Typical Performance Characteristics
Boost Diode Forward Voltage
900
800
700
600
500
400
300
200
100
0
0
50
100
150
200
BOOST DIODE CURRENT (mA)
3470 G17
Minimum Input Voltage, VOUT = 3.3V
6.0
TA = 25°C
VIN TO START
5.5
5.0
4.5
4.0
VIN TO RUN
3.5
3.0
0
50
100
150
LOAD CURRENT (mA)
200
3470 G18
Minimum Input Voltage, VOUT = 5V
8
TA = 25°C
VIN TO START
7
6
VIN TO RUN
5
4
0
50
100
150
200
LOAD CURRENT (mA)
3470 G19
Pin Functions (ThinSOT/DD)
SHDN (Pin 1/Pin 8): The SHDN pin is used to put the
LT3470 in shutdown mode. Tie to ground to shut down
the LT3470. Apply 2V or more for normal operation. If the
shutdown feature is not used, tie this pin to the VIN pin.
NC (Pin 2/Pin 7): This pin can be left floating or connected
to VIN.
VIN (Pin 3/Pin 6): The VIN pin supplies current to the
LT3470’s internal regulator and to the internal power
switch. This pin must be locally bypassed.
GND (Pin 4/Pin 5): Tie the GND pin to a local ground plane
below the LT3470 and the circuit components. Return the
feedback divider to this pin.
SW (Pin 5/Pin 4): The SW pin is the output of the internal
power switch. Connect this pin to the inductor, catch diode
and boost capacitor.
BOOST (Pin 6/Pin 3): The BOOST pin is used to provide
a drive voltage, which is higher than the input voltage, to
the internal bipolar NPN power switch.
BIAS (Pin 7/Pin 2): The BIAS pin connects to the internal
boost Schottky diode and to the internal regulator. Tie to
VOUT when VOUT > 2V or to VIN otherwise. When VBIAS >
3V the BIAS pin will supply current to the internal regulator.
FB (Pin 8/Pin 1): The LT3470 regulates its feedback pin
to 1.25V. Connect the feedback resistor divider tap to this
pin. Set the output voltage according to VOUT = 1.25V
(1 + R1/R2) or R1 = R2 (VOUT/1.25 – 1).
Exposed Pad (DD, Pin 9): Ground. Must be soldered to
PCB.
3470fd
6
Share Link: 