AH11 Просмотр технического описания (PDF) - WJ Communications => Triquint
Номер в каталоге
Компоненты Описание
производитель
AH11 Datasheet PDF : 6 Pages
| |||
AH11
High Dynamic Range Dual Amplifier
The Communications Edge TM
Product Information
Product Features
• 150 – 3000 MHz
• +44 dBm OIP3
(balanced configuration)
• +48 dBm OIP3
(dual push-pull configuration)
• Single-ended performance:
13.5 dB Gain
2.7 dB Noise Figure
+21 dBm P1dB
• Single +5 Volt Supply
• Lead-free/Green SOIC8 Pkg.
Applications
• Mobile Infrastructure
• Defense / Homeland Security
• Fixed Wireless
Product Description
The AH11 is a high linearity amplifier for use in digital
communication systems. It combines low noise figure and
high intercept point into a low-cost SMT solution. This
device extends the linear efficiency advantages of WJ’s AH1
to higher power levels by combining two internally matched
die. This dual-amplifier configuration allows for the optimal
design of balanced or push-pull operation. The amplifier
can also be used for single-ended operation in each branch
of a diversity receive system.
A mature and reliable GaAs MESFET technology is
employed to maximize linearity while achieving low noise
figure. The package is a thermally enhanced lead-free/
green/RoHS-compliant SOIC-8 package thus allowing the
device to achieve an MTTF greater than 100 years at a case
temperature of 85 °C. All devices are 100% RF and DC
tested.
Functional Diagram
1
8
2
7
3
6
4
5
Function
Input (Amp 1)
Ground
Input (Amp 2)
Output (Amp 1)
Output (Amp 2)
Pin No.
1
2, 3, 6, 7,
Bottom Slug
4
5
8
Specifications (1) (Single-ended Performance)
Parameter
Test Frequency
Gain
Input Return Loss (2)
Output Return Loss
Output IP3 (3)
Output P1dB
Noise Figure
Operating Current Range
Supply Voltage
Units
MHz
dB
dB
dB
dBm
dBm
dB
mA
V
Min
12.4
+37
120
Typ
800
13.5
8
15
+41
+21
2.7
150
+5
Max
180
1. Test conditions unless otherwise noted: T = 25 ºC, Supply Voltage = +5 V, Frequency = 800 MHz,
50 Ω System, tested on each single-ended amplifier (there are two amplifiers in an AH11 package)
2. S21 and S11 can be improved in the band of interest with some slight input tuning.
3. 3OIP measured with two tones at an output power of +5 dBm/tone separated by 10 MHz. The
suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule. Slight OIP3
degradation of about 2 dB is expected to occur at lower temperatures (from 25 ºC to –40 ºC).
Typical Performance (Balanced Configuration)
Parameter Units
Typical
Frequency
MHz
900
1900
2100
S21
dB
12.2
11.2
10.6
S11
dB
-10
-14
-10
S22
dB
-18
-10
-10
Output IP3
dBm
+46
+44
+45
Noise Figure
dB
4.1
4.2
5.6
Supply Bias
+5 V @ 300 mA
Test conditions: T = 25 ºC, in a tuned application circuit (shown on page 2)
Typical Performance (Dual P-P Configuration)
Parameter Units
Typical
Frequency
MHz
900
1900
S21
dB
13.4
11.9
S11
dB
-19
-19
S22
dB
-12
-10
Output IP3
dBm
+48
+48
Noise Figure
dB
3.4
3.7
Supply bias
+5 V @ 600 mA
Test conditions: T = 25 ºC, in a tuned application circuit (shown on pages 3 and 4)
Absolute Maximum Rating
Ordering Information
Parameter
Operating Case Temperature
Storage Temperature
Supply Voltage
RF Input Power (continuous)
Junction Temperature
Rating
-40 to +85 °C
-55 to +125 °C
+6 V
4 dB above Input P1dB
+220 °C
Part No.
AH11-G
AH11BAL-PCB
AH11PP900-PCB
AH11PP1900-PCB
Description
High Dynamic Range CATV Amplifier
(lead-free/green/RoHS-compliant SOIC-8 Package)
0.6-2.1GHz Eval Board, Balanced Configuration
0.9GHz Eval Board, Dual Push-Pull Configuration
1.9GHz Eval Board, Dual Push-Pull Configuration
Operation of this device above any of these parameters may cause permanent damage.
Specifications and information are subject to change without notice
WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6621 • e-mail: sales@wj.com • Web site: www.wj.com
Page 1 of 6 May 2006
Share Link: 