L9825TR Просмотр технического описания (PDF) - STMicroelectronics

Номер в каталоге

Компоненты Описание

производитель

L9825TR

Octal Low-side Driver For Resistive and Inductive Loads With Serial / Parallel Input Control, Output Protection and Diagnostic

STMicroelectronics 

L9825

FUNCTIONAL DESCRIPTION

General

The L9825 integrated circuit features 8 power low-side-driver outputs. Data is transmitted to the device using

the Serial Peripheral Interface, SPI protocol. Outputs 1 and 2 can be controlled parallel or serial. The power

outputs features voltage clamping function for flyback current recirculation and are protected against short cir-

cuit to Vbat.

The diagnostics recognizes two outputs fault conditions: 1) overcurrent for outputs 1 to 6 , overcurrent and ther-

mal overload for outputs 7 and 8 in switch-on condition and 2) open load or short to GND in switch-off condition

for all outputs. The outputs status can be read out via the serial interface.

The chip internal reset is a OR function of the external nRes signal and internally generated undervoltage nRes

signal.

Output Stages Control

Each output is controlled with its latch and with common reset line, which enables all eight outputs. Outputs 1

and 2 can be controlled also by its NON1, NON2 inputs. It allows PWM control independently on the SPI. These

inputs features internal pull-up resistors to assure that the outputs are switched off, when the inputs are open.

The control data are transmitted via the SDI input, the timing of the serial interface is shown in Fig. 1.

The device is selected with low NCS signal and the input data are transferred into the 8 bit shift register at every

falling CLK edge. The rising edge of the NCS latches the new data from the shift register to the drivers.

Figure 1. Timing of the Serial Interface

NCS

tsclch thclcl

tclh

tcll

CLK

tcsdv

tpcld

SDO

not defined

D8

tscld

thcld

SDI

D8

D7

tsclcl

thclch

tpchdz

D1

D1

The SPI register data are transferred to the output latch at rising NCS edge. The digital filter between NCS and

the output latch ensures that the data are transferred only after 8 CLK cycles or multiple of 8 CLK cycles since

the last NCS falling edge. The NCS changes only at low CLK.

Table 1. Outputs Control

Outputs 1, 2:

Outputs 3 to 8:

NON1,2

1

0

0

1

SPI-bit 1,2

0

0

1

1 SPI-bit 3...8

Output 1, 2

off

on

on

on Output 3...8

0

1

off

on

6/11

Share Link: