L6591TR(2008) Просмотр технического описания (PDF) - STMicroelectronics

Номер в каталоге

Компоненты Описание

производитель

L6591TR
(Rev.:2008)

PWM controller for ZVS half-bridge

STMicroelectronics 

Pin settings

2

Pin settings

2.1

Connection

Figure 3. Pin connection (top view)

LINE 1

DIS 2

ISEN 3

SS 4

OSC 5

VREF 6

COMP 7

PFC_STOP 8

16 HVSTART

15 BOOT

14 HVG

13 FGND

12 N.C.

11 GND

10 LVG

9 Vcc

L6591

2.2

Functions

Table 1.

Pin N.

1

2

Pin functions

Name

Function

LINE

DIS

Line sensing input. The pin is to be connected to the high-voltage input bus

with a resistor divider. A voltage below 1.25 V shuts down the IC, lowers its

consumption and discharges the soft-start capacitor. IC’s operation is re-

enabled as the voltage exceeds 1.25 V. The comparator is provided with

current hysteresis: an internal 15 µA current generator is ON as long as the

voltage applied at the pin is below 1.25 V and is OFF if this value is

exceeded. Bypass the pin with a capacitor to GND (#11) to reduce noise

pick-up. The pin is intended for either power-on sequencing in systems with

PFC, or brownout protection. Tie to Vcc (#9) with a 220 to 330 kW resistor if

the function is not used.

Latched device shutdown. Internally the pin connects a comparator that,

when the voltage on the pin exceeds 4.5 V, shuts the IC down and brings its

consumption to a value barely higher than before start-up. The information

is latched and it is necessary to recycle the input power to restart the IC: the

latch is removed as the voltage on the Vcc pin (#9) goes below the UVLO

threshold. Connect the pin to GND (#11) if the function is not used.

4/32

Share Link: