6115CBZ(2010) Просмотр технического описания (PDF) - Intersil
Номер в каталоге
Компоненты Описание
производитель
6115CBZ Datasheet PDF : 13 Pages
| |||
ISL6115, ISL6116, ISL6117, ISL6120
Pin Descriptions
PIN # SYMBOL
FUNCTION
DESCRIPTION
1
ISET Current Set
Connect to the low side of the current sense resistor through the current limiting set resistor.
This pin functions as the current limit programming pin.
2
ISEN Current Sense
Connect to the more positive end of sense resistor to measure the voltage drop across this
resistor.
3
GATE External FET Gate
Connect to the gate of the external N-Channel MOSFET. A capacitor from this node to
Drive Pin
ground sets the turn-on ramp. At turn-on this capacitor will be charged to VDD +5V
(ISL6115) and to VDD (ISL6116, ISL6117, ISL6120) by a 10µA current source.
4
VSS Chip Return
5
VDD Chip Supply
12V chip supply. This can be either connected directly to the +12V rail supplying the
switched load voltage or to a dedicated VSS +12V supply.
6
CTIM Current Limit Timing Connect a capacitor from this pin to ground. This capacitor determines the time delay
Capacitor
between an overcurrent event and chip output shutdown (current limit time-out). The
duration of current limit time-out is equal to 93kΩ x CTIM.
7
PGOOD Power Good Indicator Indicates that the voltage on the ISEN pin is satisfactory. PGOOD is driven by an open
drain N-Channel MOSFET and is pulled low when the output voltage (VISEN) is less than
the UV level for the particular IC.
8
PWRON Power-ON
PWRON is used to control and reset the chip. The chip is enabled when PWRON pin is
driven high to a maximum of 5V or is left open. Do not drive this input >5V. After a
current limit time-out, the chip is reset by a low level signal applied to this pin. This input
has 20µA pull-up capability.
3
FN9100.7
April 29, 2010
Share Link: 