HEDS-6140-B08 Просмотр технического описания (PDF) - HP => Agilent Technologies

Номер в каталоге

Компоненты Описание

производитель

HEDS-6140-B08

Two and Three Channel Codewheels for use with Agilent Optical Encoder Modules

HP => Agilent Technologies 

5

Assembly Instructions Using

Agilent Assembly Tools

Instructions

shim should not contact the

1. Place codewheel on shaft.

codewheel boss.

2. Set codewheel height:

(a) Place the correct gap

setting tool (per Ordering

Information Table) on motor

base, flush up against the

motor shaft as shown in Figure

(b) Push codewheel down

against gap setting shim. The

codewheel is now at the proper

height.

(c) Tighten codewheel

setscrew.

2. The shim has two different

3. Insert mounting screws

size steps. Choose the one that

through module and thread

most closely matches the width

into the motor base. Do not

of the codewheel boss. The

tighten screws.

4. Slide the HEDS-8905 or HEDS-

8906 centering tool over

codewheel hub and onto

module as shown in Figure 3.

The pins of the alignment tool

should fit snugly inside the

alignment recesses of the

module.

5. While holding alignment tool in

place, tighten screws down to

secure module.

6. Remove alignment tools.

IMAGE SIDE OF CODEWHEEL

GAP SETTING SHIM

CODEWHEEL

MODULE SIDE A

MODULE SIDE B

CENTERING TOOL

CODEWHEEL

ALIGNING RECESSES

MODULE SIDE A

MODULE SIDE B

Figure 2. Alignment Tool is Used to Set Height of

Codewheel.

Figure 3. Alignment Tool is Placed over Shaft and onto

Codewheel Hub. Alignment Tool Pins Mate with

Aligning Recesses on Module.

Share Link: